OMAPDSS: DSI: get line buffer size at probe
To find out the DSI line buffer size we need to read HW registers. To
make it possible to do DSI configuration calculations without HW powered
up, store the line buffer size at DSI driver's probe.
Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ti.com>
diff --git a/drivers/video/omap2/dss/dsi.c b/drivers/video/omap2/dss/dsi.c
index 8cb43af60f..590da06 100644
--- a/drivers/video/omap2/dss/dsi.c
+++ b/drivers/video/omap2/dss/dsi.c
@@ -336,6 +336,7 @@
unsigned long lpdiv_max;
unsigned num_lanes_supported;
+ unsigned line_buffer_size;
struct dsi_lane_config lanes[DSI_MAX_NR_LANES];
unsigned num_lanes_used;
@@ -3791,13 +3792,12 @@
if (dsi->mode == OMAP_DSS_DSI_VIDEO_MODE) {
int bpp = dsi_get_pixel_size(dsi->pix_fmt);
- unsigned line_buf_size = dsi_get_line_buf_size(dsidev);
struct omap_video_timings *timings = &dsi->timings;
/*
* Don't use line buffers if width is greater than the video
* port's line buffer size
*/
- if (line_buf_size <= timings->x_res * bpp / 8)
+ if (dsi->line_buffer_size <= timings->x_res * bpp / 8)
num_line_buffers = 0;
else
num_line_buffers = 2;
@@ -4447,7 +4447,7 @@
u32 l;
int r;
const unsigned channel = dsi->update_channel;
- const unsigned line_buf_size = dsi_get_line_buf_size(dsidev);
+ const unsigned line_buf_size = dsi->line_buffer_size;
u16 w = dsi->timings.x_res;
u16 h = dsi->timings.y_res;
@@ -5293,6 +5293,8 @@
else
dsi->num_lanes_supported = 3;
+ dsi->line_buffer_size = dsi_get_line_buf_size(dsidev);
+
dsi_init_output(dsidev);
dsi_probe_pdata(dsidev);