gpio: dt-bindings: add ibm,ppc4xx-gpio binding
This patch adds binding information for IBM/AMCC/APM GPIO
Controllers of the PowerPC 4XX series and compatible SoCs.
The "PowerPC 405EP Embedded Processor Data Sheet" has the
following to say about the GPIO controllers: "
- Controller functions and GPIO registers are programmed
and accessed via memory-mapped OPB bus master accesses
- All GPIOs are pin-shared with other functions. DCRs control
whether a particular pin that has GPIO capabilities acts
as a GPIO or is used for another purpose.
- Each GPIO outputs is separately programmable to emulate
an open-drain driver (i.e. drives to zero, threestated if
output bit is 1)
"
The ppc4xx_gpio.c driver is part of the platform/sysdev drivers
in arch/powerpc/sysdev.
Signed-off-by: Christian Lamparter <chunkeey@googlemail.com>
Signed-off-by: Rob Herring <robh@kernel.org>
diff --git a/Documentation/devicetree/bindings/gpio/ibm,ppc4xx-gpio.txt b/Documentation/devicetree/bindings/gpio/ibm,ppc4xx-gpio.txt
new file mode 100644
index 0000000..d58b395
--- /dev/null
+++ b/Documentation/devicetree/bindings/gpio/ibm,ppc4xx-gpio.txt
@@ -0,0 +1,24 @@
+* IBM/AMCC/APM GPIO Controller for PowerPC 4XX series and compatible SoCs
+
+All GPIOs are pin-shared with other functions. DCRs control whether a
+particular pin that has GPIO capabilities acts as a GPIO or is used for
+another purpose. GPIO outputs are separately programmable to emulate
+an open-drain driver.
+
+Required properties:
+ - compatible: must be "ibm,ppc4xx-gpio"
+ - reg: address and length of the register set for the device
+ - #gpio-cells: must be set to 2. The first cell is the pin number
+ and the second cell is used to specify the gpio polarity:
+ 0 = active high
+ 1 = active low
+ - gpio-controller: marks the device node as a gpio controller.
+
+Example:
+
+GPIO0: gpio@ef600b00 {
+ compatible = "ibm,ppc4xx-gpio";
+ reg = <0xef600b00 0x00000048>;
+ #gpio-cells = <2>;
+ gpio-controller;
+};