ieee802154: add TX power control to wpan_phy
Replace the current u8 transmit_power in wpan_phy with s8 transmit_power.
The u8 field contained the actual tx power and a tolerance field,
which no physical radio every used. Adjust sysfs entries to keep
compatibility with userspace, give tolerances of +-1dB statically there.
This patch only adds support for this in the at86rf230 driver and the
RF212 chip. Configuration calculation for RF212 is also somewhat basic,
but does the job - the RF212 datasheet gives a large table with
suggested values for combinations of TX power and page/channel, if this
does not work well, we might have to copy the whole table.
Signed-off-by: Phoebe Buckheister <phoebe.buckheister@itwm.fraunhofer.de>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ieee802154/at86rf230.c b/drivers/net/ieee802154/at86rf230.c
index bd1ef0b..9afb4b9d 100644
--- a/drivers/net/ieee802154/at86rf230.c
+++ b/drivers/net/ieee802154/at86rf230.c
@@ -753,6 +753,30 @@
return 0;
}
+static int
+at86rf212_set_txpower(struct ieee802154_dev *dev, int db)
+{
+ struct at86rf230_local *lp = dev->priv;
+ int rc;
+
+ /* typical maximum output is 5dBm with RG_PHY_TX_PWR 0x60, lower five
+ * bits decrease power in 1dB steps. 0x60 represents extra PA gain of
+ * 0dB.
+ * thus, supported values for db range from -26 to 5, for 31dB of
+ * reduction to 0dB of reduction.
+ */
+ if (db > 5 || db < -26)
+ return -EINVAL;
+
+ db = -(db - 5);
+
+ rc = __at86rf230_write(lp, RG_PHY_TX_PWR, 0x60 | db);
+ if (rc)
+ return rc;
+
+ return 0;
+}
+
static struct ieee802154_ops at86rf230_ops = {
.owner = THIS_MODULE,
.xmit = at86rf230_xmit,
@@ -771,6 +795,7 @@
.start = at86rf230_start,
.stop = at86rf230_stop,
.set_hw_addr_filt = at86rf230_set_hw_addr_filt,
+ .set_txpower = at86rf212_set_txpower,
};
static void at86rf230_irqwork(struct work_struct *work)
diff --git a/include/linux/nl802154.h b/include/linux/nl802154.h
index fd4f2d1..625d19e 100644
--- a/include/linux/nl802154.h
+++ b/include/linux/nl802154.h
@@ -70,6 +70,8 @@
IEEE802154_ATTR_PHY_NAME,
IEEE802154_ATTR_DEV_TYPE,
+ IEEE802154_ATTR_TXPOWER,
+
__IEEE802154_ATTR_MAX,
};
@@ -122,6 +124,8 @@
IEEE802154_ADD_IFACE,
IEEE802154_DEL_IFACE,
+ IEEE802154_SET_PHYPARAMS,
+
__IEEE802154_CMD_MAX,
};
diff --git a/include/net/mac802154.h b/include/net/mac802154.h
index 807d6b7..8bd2785 100644
--- a/include/net/mac802154.h
+++ b/include/net/mac802154.h
@@ -113,6 +113,10 @@
* Set radio for listening on specific address.
* Set the device for listening on specified address.
* Returns either zero, or negative errno.
+ *
+ * set_txpower:
+ * Set radio transmit power in dB. Called with pib_lock held.
+ * Returns either zero, or negative errno.
*/
struct ieee802154_ops {
struct module *owner;
@@ -129,6 +133,7 @@
unsigned long changed);
int (*ieee_addr)(struct ieee802154_dev *dev,
u8 addr[IEEE802154_ADDR_LEN]);
+ int (*set_txpower)(struct ieee802154_dev *dev, int db);
};
/* Basic interface to register ieee802154 device */
diff --git a/include/net/wpan-phy.h b/include/net/wpan-phy.h
index b52bda8..47fc0c1 100644
--- a/include/net/wpan-phy.h
+++ b/include/net/wpan-phy.h
@@ -37,14 +37,14 @@
struct mutex pib_lock;
/*
- * This is a PIB according to 802.15.4-2006.
+ * This is a PIB according to 802.15.4-2011.
* We do not provide timing-related variables, as they
* aren't used outside of driver
*/
u8 current_channel;
u8 current_page;
u32 channels_supported[32];
- u8 transmit_power;
+ s8 transmit_power;
u8 cca_mode;
struct device dev;
@@ -54,6 +54,8 @@
const char *name, int type);
void (*del_iface)(struct wpan_phy *phy, struct net_device *dev);
+ int (*set_txpower)(struct wpan_phy *phy, int db);
+
char priv[0] __attribute__((__aligned__(NETDEV_ALIGN)));
};
diff --git a/net/ieee802154/ieee802154.h b/net/ieee802154/ieee802154.h
index cee4425..6cbc896 100644
--- a/net/ieee802154/ieee802154.h
+++ b/net/ieee802154/ieee802154.h
@@ -53,6 +53,7 @@
int ieee802154_dump_phy(struct sk_buff *skb, struct netlink_callback *cb);
int ieee802154_add_iface(struct sk_buff *skb, struct genl_info *info);
int ieee802154_del_iface(struct sk_buff *skb, struct genl_info *info);
+int ieee802154_set_phyparams(struct sk_buff *skb, struct genl_info *info);
enum ieee802154_mcgrp_ids {
IEEE802154_COORD_MCGRP,
diff --git a/net/ieee802154/netlink.c b/net/ieee802154/netlink.c
index 43f1b2b..67c151b 100644
--- a/net/ieee802154/netlink.c
+++ b/net/ieee802154/netlink.c
@@ -115,6 +115,7 @@
ieee802154_dump_phy),
IEEE802154_OP(IEEE802154_ADD_IFACE, ieee802154_add_iface),
IEEE802154_OP(IEEE802154_DEL_IFACE, ieee802154_del_iface),
+ IEEE802154_OP(IEEE802154_SET_PHYPARAMS, ieee802154_set_phyparams),
/* see nl-mac.c */
IEEE802154_OP(IEEE802154_ASSOCIATE_REQ, ieee802154_associate_req),
IEEE802154_OP(IEEE802154_ASSOCIATE_RESP, ieee802154_associate_resp),
diff --git a/net/ieee802154/nl-phy.c b/net/ieee802154/nl-phy.c
index 89b265a..d3ee62f 100644
--- a/net/ieee802154/nl-phy.c
+++ b/net/ieee802154/nl-phy.c
@@ -55,7 +55,8 @@
mutex_lock(&phy->pib_lock);
if (nla_put_string(msg, IEEE802154_ATTR_PHY_NAME, wpan_phy_name(phy)) ||
nla_put_u8(msg, IEEE802154_ATTR_PAGE, phy->current_page) ||
- nla_put_u8(msg, IEEE802154_ATTR_CHANNEL, phy->current_channel))
+ nla_put_u8(msg, IEEE802154_ATTR_CHANNEL, phy->current_channel) ||
+ nla_put_s8(msg, IEEE802154_ATTR_TXPOWER, phy->transmit_power))
goto nla_put_failure;
for (i = 0; i < 32; i++) {
if (phy->channels_supported[i])
@@ -354,3 +355,49 @@
return rc;
}
+
+int ieee802154_set_phyparams(struct sk_buff *skb, struct genl_info *info)
+{
+ struct wpan_phy *phy;
+ const char *name;
+ int txpower;
+ int rc = -EINVAL;
+
+ pr_debug("%s\n", __func__);
+
+ if (!info->attrs[IEEE802154_ATTR_PHY_NAME])
+ return -EINVAL;
+
+ name = nla_data(info->attrs[IEEE802154_ATTR_PHY_NAME]);
+ if (name[nla_len(info->attrs[IEEE802154_ATTR_PHY_NAME]) - 1] != '\0')
+ return -EINVAL; /* phy name should be null-terminated */
+
+ txpower = nla_get_s8(info->attrs[IEEE802154_ATTR_TXPOWER]);
+
+ phy = wpan_phy_find(name);
+ if (!phy)
+ return -ENODEV;
+
+ if (!phy->set_txpower)
+ goto out;
+
+ mutex_lock(&phy->pib_lock);
+
+ rc = phy->set_txpower(phy, txpower);
+ if (rc < 0) {
+ mutex_unlock(&phy->pib_lock);
+ goto out;
+ }
+
+ phy->transmit_power = txpower;
+
+ mutex_unlock(&phy->pib_lock);
+
+ wpan_phy_put(phy);
+
+ return 0;
+
+out:
+ wpan_phy_put(phy);
+ return rc;
+}
diff --git a/net/ieee802154/nl_policy.c b/net/ieee802154/nl_policy.c
index 6adda4d..90b1d0d 100644
--- a/net/ieee802154/nl_policy.c
+++ b/net/ieee802154/nl_policy.c
@@ -52,5 +52,7 @@
[IEEE802154_ATTR_DURATION] = { .type = NLA_U8, },
[IEEE802154_ATTR_ED_LIST] = { .len = 27 },
[IEEE802154_ATTR_CHANNEL_PAGE_LIST] = { .len = 32 * 4, },
+
+ [IEEE802154_ATTR_TXPOWER] = { .type = NLA_S8, },
};
diff --git a/net/ieee802154/wpan-class.c b/net/ieee802154/wpan-class.c
index 4dd3761..8d6f670 100644
--- a/net/ieee802154/wpan-class.c
+++ b/net/ieee802154/wpan-class.c
@@ -44,9 +44,7 @@
MASTER_SHOW(current_channel, "%d");
MASTER_SHOW(current_page, "%d");
-MASTER_SHOW_COMPLEX(transmit_power, "%d +- %d dB",
- ((signed char) (phy->transmit_power << 2)) >> 2,
- (phy->transmit_power >> 6) ? (phy->transmit_power >> 6) * 3 : 1);
+MASTER_SHOW(transmit_power, "%d +- 1 dB");
MASTER_SHOW(cca_mode, "%d");
static ssize_t channels_supported_show(struct device *dev,
diff --git a/net/mac802154/ieee802154_dev.c b/net/mac802154/ieee802154_dev.c
index 52ae664..9eb49e0 100644
--- a/net/mac802154/ieee802154_dev.c
+++ b/net/mac802154/ieee802154_dev.c
@@ -165,6 +165,16 @@
return ERR_PTR(err);
}
+static int mac802154_set_txpower(struct wpan_phy *phy, int db)
+{
+ struct mac802154_priv *priv = wpan_phy_priv(phy);
+
+ if (!priv->ops->set_txpower)
+ return -ENOTSUPP;
+
+ return priv->ops->set_txpower(&priv->hw, db);
+}
+
struct ieee802154_dev *
ieee802154_alloc_device(size_t priv_data_len, struct ieee802154_ops *ops)
{
@@ -242,6 +252,7 @@
priv->phy->add_iface = mac802154_add_iface;
priv->phy->del_iface = mac802154_del_iface;
+ priv->phy->set_txpower = mac802154_set_txpower;
rc = wpan_phy_register(priv->phy);
if (rc < 0)