[ARM] pxa/vpac270: Convert to use PATA PXA driver
Signed-off-by: Marek Vasut <marek.vasut@gmail.com>
Signed-off-by: Eric Miao <eric.y.miao@gmail.com>
diff --git a/arch/arm/mach-pxa/vpac270.c b/arch/arm/mach-pxa/vpac270.c
index 9884fa9..fb4b801 100644
--- a/arch/arm/mach-pxa/vpac270.c
+++ b/arch/arm/mach-pxa/vpac270.c
@@ -37,6 +37,7 @@
#include <mach/ohci.h>
#include <mach/pxa27x-udc.h>
#include <mach/udc.h>
+#include <mach/pata_pxa.h>
#include <plat/i2c.h>
@@ -538,9 +539,10 @@
/******************************************************************************
* PATA IDE
******************************************************************************/
-#if defined(CONFIG_PATA_PLATFORM) || defined(CONFIG_PATA_PLATFORM_MODULE)
-static struct pata_platform_info vpac270_pata_pdata = {
- .ioport_shift = 1,
+#if defined(CONFIG_PATA_PXA) || defined(CONFIG_PATA_PXA_MODULE)
+static struct pata_pxa_pdata vpac270_pata_pdata = {
+ .reg_shift = 1,
+ .dma_dreq = 1,
.irq_flags = IRQF_TRIGGER_RISING,
};
@@ -555,7 +557,12 @@
.end = PXA_CS3_PHYS + 0x15f,
.flags = IORESOURCE_MEM
},
- [2] = { /* IDE IRQ pin */
+ [2] = { /* DMA Base address */
+ .start = PXA_CS3_PHYS + 0x20,
+ .end = PXA_CS3_PHYS + 0x2f,
+ .flags = IORESOURCE_DMA
+ },
+ [3] = { /* IDE IRQ pin */
.start = gpio_to_irq(GPIO36_VPAC270_IDE_IRQ),
.end = gpio_to_irq(GPIO36_VPAC270_IDE_IRQ),
.flags = IORESOURCE_IRQ
@@ -563,11 +570,12 @@
};
static struct platform_device vpac270_ide_device = {
- .name = "pata_platform",
+ .name = "pata_pxa",
.num_resources = ARRAY_SIZE(vpac270_ide_resources),
.resource = vpac270_ide_resources,
.dev = {
.platform_data = &vpac270_pata_pdata,
+ .coherent_dma_mask = 0xffffffff,
}
};