usb: musb dma: add cppi41 dma driver
This driver is currently used by musb' cppi41 couter part. I may merge
both dma engine user of musb at some point but not just yet.
The driver seems to work in RX/TX mode in host mode, tested on mass
storage. I increaed the size of the TX / RX transfers and waited for the
core code to cancel a transfers and it seems to recover.
v2..3:
- use mall transfers on RX side and check data toggle.
- use rndis mode on tx side so we haveon interrupt for 4096 transfers.
- remove custom "transferred" hack and use dmaengine_tx_status() to
compute the total amount of data that has been transferred.
- cancel transfers and reclaim descriptors
v1..v2:
- RX path added
- dma mode 0 & 1 is working
- device tree nodes re-created.
Cc: Vinod Koul <vinod.koul@intel.com>
Cc: Dan Williams <djbw@fb.com>
Signed-off-by: Sebastian Andrzej Siewior <bigeasy@linutronix.de>
Signed-off-by: Felipe Balbi <balbi@ti.com>
diff --git a/drivers/dma/Kconfig b/drivers/dma/Kconfig
index 6825957..77bc480 100644
--- a/drivers/dma/Kconfig
+++ b/drivers/dma/Kconfig
@@ -287,6 +287,14 @@
select DMA_ENGINE
select DMA_VIRTUAL_CHANNELS
+config TI_CPPI41
+ tristate "AM33xx CPPI41 DMA support"
+ depends on ARCH_OMAP
+ select DMA_ENGINE
+ help
+ The Communications Port Programming Interface (CPPI) 4.1 DMA engine
+ is currently used by the USB driver on AM335x platforms.
+
config MMP_PDMA
bool "MMP PDMA support"
depends on (ARCH_MMP || ARCH_PXA)