IB/ipath: Remove support for preproduction HTX InfiniPath cards
Clean up some code by removing support for some older pre-production
HTX InfiniPath cards.
Signed-off-by: Ralph Campbell <ralph.campbell@qlogic.com>
diff --git a/drivers/infiniband/hw/ipath/ipath_driver.c b/drivers/infiniband/hw/ipath/ipath_driver.c
index c40a542..da4a2cf 100644
--- a/drivers/infiniband/hw/ipath/ipath_driver.c
+++ b/drivers/infiniband/hw/ipath/ipath_driver.c
@@ -1021,14 +1021,10 @@
goto bail;
}
- /* There is already a thread processing this queue. */
- if (test_and_set_bit(0, &dd->ipath_rcv_pending))
- goto bail;
-
l = dd->ipath_port0head;
hdrqtail = (u32) le64_to_cpu(*dd->ipath_hdrqtailptr);
if (l == hdrqtail)
- goto done;
+ goto bail;
reloop:
for (i = 0; l != hdrqtail; i++) {
@@ -1163,10 +1159,6 @@
ipath_stats.sps_avgpkts_call =
ipath_stats.sps_port0pkts / ++totcalls;
-done:
- clear_bit(0, &dd->ipath_rcv_pending);
- smp_mb__after_clear_bit();
-
bail:;
}
diff --git a/drivers/infiniband/hw/ipath/ipath_iba6110.c b/drivers/infiniband/hw/ipath/ipath_iba6110.c
index fdfa95d..650745d 100644
--- a/drivers/infiniband/hw/ipath/ipath_iba6110.c
+++ b/drivers/infiniband/hw/ipath/ipath_iba6110.c
@@ -677,6 +677,12 @@
if (n)
snprintf(name, namelen, "%s", n);
+ if (dd->ipath_boardrev != 6 && dd->ipath_boardrev != 7 &&
+ dd->ipath_boardrev != 11) {
+ ipath_dev_err(dd, "Unsupported InfiniPath board %s!\n", name);
+ ret = 1;
+ goto bail;
+ }
if (dd->ipath_majrev != 3 || (dd->ipath_minrev < 2 ||
dd->ipath_minrev > 4)) {
/*
@@ -694,36 +700,11 @@
* copies
*/
dd->ipath_flags |= IPATH_32BITCOUNTERS;
+ dd->ipath_flags |= IPATH_GPIO_INTR;
if (dd->ipath_htspeed != 800)
ipath_dev_err(dd,
"Incorrectly configured for HT @ %uMHz\n",
dd->ipath_htspeed);
- if (dd->ipath_boardrev == 7 || dd->ipath_boardrev == 11 ||
- dd->ipath_boardrev == 6)
- dd->ipath_flags |= IPATH_GPIO_INTR;
- else
- dd->ipath_flags |= IPATH_POLL_RX_INTR;
- if (dd->ipath_boardrev == 8) { /* LS/X-1 */
- u64 val;
- val = ipath_read_kreg64(dd, dd->ipath_kregs->kr_extstatus);
- if (val & INFINIPATH_EXTS_SERDESSEL) {
- /*
- * hardware disabled
- *
- * This means that the chip is hardware disabled,
- * and will not be able to bring up the link,
- * in any case. We special case this and abort
- * early, to avoid later messages. We also set
- * the DISABLED status bit
- */
- ipath_dbg("Unit %u is hardware-disabled\n",
- dd->ipath_unit);
- *dd->ipath_statusp |= IPATH_STATUS_DISABLED;
- /* this value is handled differently */
- ret = 2;
- goto bail;
- }
- }
ret = 0;
bail:
@@ -1574,8 +1555,10 @@
* with 128, rather than 112.
*/
dd->ipath_flags |= IPATH_GPIO_INTR;
- dd->ipath_flags &= ~IPATH_POLL_RX_INTR;
- }
+ } else
+ ipath_dev_err(dd, "Unsupported InfiniPath serial "
+ "number %.16s!\n", dd->ipath_serial);
+
return 0;
}
diff --git a/drivers/infiniband/hw/ipath/ipath_kernel.h b/drivers/infiniband/hw/ipath/ipath_kernel.h
index 8bad3e3..a27e062 100644
--- a/drivers/infiniband/hw/ipath/ipath_kernel.h
+++ b/drivers/infiniband/hw/ipath/ipath_kernel.h
@@ -391,9 +391,6 @@
struct class_device *diag_class_dev;
/* timer used to prevent stats overflow, error throttling, etc. */
struct timer_list ipath_stats_timer;
- /* check for stale messages in rcv queue */
- /* only allow one intr at a time. */
- unsigned long ipath_rcv_pending;
void *ipath_dummy_hdrq; /* used after port close */
dma_addr_t ipath_dummy_hdrq_phys;
@@ -740,7 +737,6 @@
* are 64bit */
#define IPATH_32BITCOUNTERS 0x20000
/* can miss port0 rx interrupts */
-#define IPATH_POLL_RX_INTR 0x40000
#define IPATH_DISABLED 0x80000 /* administratively disabled */
/* Use GPIO interrupts for new counters */
#define IPATH_GPIO_ERRINTRS 0x100000
diff --git a/drivers/infiniband/hw/ipath/ipath_verbs.c b/drivers/infiniband/hw/ipath/ipath_verbs.c
index c76ea0e..65f7181 100644
--- a/drivers/infiniband/hw/ipath/ipath_verbs.c
+++ b/drivers/infiniband/hw/ipath/ipath_verbs.c
@@ -1375,13 +1375,6 @@
{
struct ipath_devdata *dd = (struct ipath_devdata *) arg;
- /*
- * If port 0 receive packet interrupts are not available, or
- * can be missed, poll the receive queue
- */
- if (dd->ipath_flags & IPATH_POLL_RX_INTR)
- ipath_kreceive(dd);
-
/* Handle verbs layer timeouts. */
ipath_ib_timer(dd->verbs_dev);