serial: sh-sci: support lower baud rate
Support prescaler 1/16 and 1/64, in addition to current 1 and 1/4.
Supporting below 2400bps was dropped long time ago in mainline.
Since then, setting lower rate has been resulting in erroneous
register value, without indicating any errors through API.
This patch adds more prescaler to support lower rates again.
This still doesn't check range, but we won't hit the case because
even 50bps at 48MHz clock is now supported.
Signed-off-by: Takashi Yoshii <takashi.yoshii.zj@renesas.com>
Signed-off-by: Shinya Kuribayashi <shinya.kuribayashi.px@renesas.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/tty/serial/sh-sci.c b/drivers/tty/serial/sh-sci.c
index 6c1fddb..a54c47d 100644
--- a/drivers/tty/serial/sh-sci.c
+++ b/drivers/tty/serial/sh-sci.c
@@ -1815,7 +1815,7 @@
{
struct sci_port *s = to_sci_port(port);
struct plat_sci_reg *reg;
- unsigned int baud, smr_val, max_baud;
+ unsigned int baud, smr_val, max_baud, cks;
int t = -1;
/*
@@ -1849,21 +1849,18 @@
uart_update_timeout(port, termios->c_cflag, baud);
- serial_port_out(port, SCSMR, smr_val);
+ for (cks = 0; t >= 256 && cks <= 3; cks++)
+ t >>= 2;
- dev_dbg(port->dev, "%s: SMR %x, t %x, SCSCR %x\n", __func__, smr_val, t,
- s->cfg->scscr);
+ dev_dbg(port->dev, "%s: SMR %x, cks %x, t %x, SCSCR %x\n",
+ __func__, smr_val, cks, t, s->cfg->scscr);
if (t >= 0) {
- if (t >= 256) {
- serial_port_out(port, SCSMR, (serial_port_in(port, SCSMR) & ~3) | 1);
- t >>= 2;
- } else
- serial_port_out(port, SCSMR, serial_port_in(port, SCSMR) & ~3);
-
+ serial_port_out(port, SCSMR, (smr_val & ~3) | cks);
serial_port_out(port, SCBRR, t);
udelay((1000000+(baud-1)) / baud); /* Wait one bit interval */
- }
+ } else
+ serial_port_out(port, SCSMR, smr_val);
sci_init_pins(port, termios->c_cflag);