brcmfmac: add dedicated debug level for firmware console logging
Both PCIe and SDIO devices have the possibility to log the firmware
console output in kernel log. For PCIe it is logged when PCIE debug
level is enabled. For SDIO it is logged when user specifies a non-zero
console interval through debugfs. This patch tries to make it a
bit more consistent. The firmware console output is only logged when
FWCON debug level is enabled.
Reviewed-by: Hante Meuleman <meuleman@broadcom.com>
Reviewed-by: Franky (Zhenhui) Lin <frankyl@broadcom.com>
Reviewed-by: Pieter-Paul Giesberts <pieterpg@broadcom.com>
Reviewed-by: Pontus Fuchs <pontusf@broadcom.com>
Signed-off-by: Arend van Spriel <arend@broadcom.com>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>
diff --git a/drivers/net/wireless/brcm80211/brcmfmac/sdio.c b/drivers/net/wireless/brcm80211/brcmfmac/sdio.c
index f990e3d..e41bf44 100644
--- a/drivers/net/wireless/brcm80211/brcmfmac/sdio.c
+++ b/drivers/net/wireless/brcm80211/brcmfmac/sdio.c
@@ -123,6 +123,7 @@
#define BRCMF_FIRSTREAD (1 << 6)
+#define BRCMF_CONSOLE 10 /* watchdog interval to poll console */
/* SBSDIO_DEVICE_CTL */
@@ -3204,6 +3205,8 @@
if (IS_ERR_OR_NULL(dentry))
return;
+ bus->console_interval = BRCMF_CONSOLE;
+
brcmf_debugfs_add_entry(drvr, "forensics", brcmf_sdio_forensic_read);
brcmf_debugfs_add_entry(drvr, "counters",
brcmf_debugfs_sdio_count_read);
@@ -3613,7 +3616,7 @@
}
#ifdef DEBUG
/* Poll for console output periodically */
- if (bus->sdiodev->state == BRCMF_SDIOD_DATA &&
+ if (bus->sdiodev->state == BRCMF_SDIOD_DATA && BRCMF_FWCON_ON() &&
bus->console_interval != 0) {
bus->console.count += BRCMF_WD_POLL_MS;
if (bus->console.count >= bus->console_interval) {