| /* |
| * Copyright (C) 2011 Freescale Semiconductor, Inc. All Rights Reserved. |
| * |
| * The code contained herein is licensed under the GNU General Public |
| * License. You may obtain a copy of the GNU General Public License |
| * Version 2 or later at the following locations: |
| * |
| * http://www.opensource.org/licenses/gpl-license.html |
| * http://www.gnu.org/copyleft/gpl.html |
| */ |
| #include <linux/suspend.h> |
| #include <linux/clk.h> |
| #include <linux/io.h> |
| #include <linux/err.h> |
| #include <linux/export.h> |
| #include <asm/cacheflush.h> |
| #include <asm/system_misc.h> |
| #include <asm/tlbflush.h> |
| #include <mach/common.h> |
| #include <mach/cpuidle.h> |
| #include <mach/hardware.h> |
| #include "crm-regs-imx5.h" |
| |
| /* |
| * The WAIT_UNCLOCKED_POWER_OFF state only requires <= 500ns to exit. |
| * This is also the lowest power state possible without affecting |
| * non-cpu parts of the system. For these reasons, imx5 should default |
| * to always using this state for cpu idling. The PM_SUSPEND_STANDBY also |
| * uses this state and needs to take no action when registers remain confgiured |
| * for this state. |
| */ |
| #define IMX5_DEFAULT_CPU_IDLE_STATE WAIT_UNCLOCKED_POWER_OFF |
| |
| /* |
| * set cpu low power mode before WFI instruction. This function is called |
| * mx5 because it can be used for mx50, mx51, and mx53. |
| */ |
| static void mx5_cpu_lp_set(enum mxc_cpu_pwr_mode mode) |
| { |
| u32 plat_lpc, arm_srpgcr, ccm_clpcr; |
| u32 empgc0, empgc1; |
| int stop_mode = 0; |
| |
| /* always allow platform to issue a deep sleep mode request */ |
| plat_lpc = __raw_readl(MXC_CORTEXA8_PLAT_LPC) & |
| ~(MXC_CORTEXA8_PLAT_LPC_DSM); |
| ccm_clpcr = __raw_readl(MXC_CCM_CLPCR) & ~(MXC_CCM_CLPCR_LPM_MASK); |
| arm_srpgcr = __raw_readl(MXC_SRPG_ARM_SRPGCR) & ~(MXC_SRPGCR_PCR); |
| empgc0 = __raw_readl(MXC_SRPG_EMPGC0_SRPGCR) & ~(MXC_SRPGCR_PCR); |
| empgc1 = __raw_readl(MXC_SRPG_EMPGC1_SRPGCR) & ~(MXC_SRPGCR_PCR); |
| |
| switch (mode) { |
| case WAIT_CLOCKED: |
| break; |
| case WAIT_UNCLOCKED: |
| ccm_clpcr |= 0x1 << MXC_CCM_CLPCR_LPM_OFFSET; |
| break; |
| case WAIT_UNCLOCKED_POWER_OFF: |
| case STOP_POWER_OFF: |
| plat_lpc |= MXC_CORTEXA8_PLAT_LPC_DSM |
| | MXC_CORTEXA8_PLAT_LPC_DBG_DSM; |
| if (mode == WAIT_UNCLOCKED_POWER_OFF) { |
| ccm_clpcr |= 0x1 << MXC_CCM_CLPCR_LPM_OFFSET; |
| ccm_clpcr &= ~MXC_CCM_CLPCR_VSTBY; |
| ccm_clpcr &= ~MXC_CCM_CLPCR_SBYOS; |
| stop_mode = 0; |
| } else { |
| ccm_clpcr |= 0x2 << MXC_CCM_CLPCR_LPM_OFFSET; |
| ccm_clpcr |= 0x3 << MXC_CCM_CLPCR_STBY_COUNT_OFFSET; |
| ccm_clpcr |= MXC_CCM_CLPCR_VSTBY; |
| ccm_clpcr |= MXC_CCM_CLPCR_SBYOS; |
| stop_mode = 1; |
| } |
| arm_srpgcr |= MXC_SRPGCR_PCR; |
| break; |
| case STOP_POWER_ON: |
| ccm_clpcr |= 0x2 << MXC_CCM_CLPCR_LPM_OFFSET; |
| break; |
| default: |
| printk(KERN_WARNING "UNKNOWN cpu power mode: %d\n", mode); |
| return; |
| } |
| |
| __raw_writel(plat_lpc, MXC_CORTEXA8_PLAT_LPC); |
| __raw_writel(ccm_clpcr, MXC_CCM_CLPCR); |
| __raw_writel(arm_srpgcr, MXC_SRPG_ARM_SRPGCR); |
| |
| /* Enable NEON SRPG for all but MX50TO1.0. */ |
| if (mx50_revision() != IMX_CHIP_REVISION_1_0) |
| __raw_writel(arm_srpgcr, MXC_SRPG_NEON_SRPGCR); |
| |
| if (stop_mode) { |
| empgc0 |= MXC_SRPGCR_PCR; |
| empgc1 |= MXC_SRPGCR_PCR; |
| |
| __raw_writel(empgc0, MXC_SRPG_EMPGC0_SRPGCR); |
| __raw_writel(empgc1, MXC_SRPG_EMPGC1_SRPGCR); |
| } |
| } |
| |
| static int mx5_suspend_enter(suspend_state_t state) |
| { |
| switch (state) { |
| case PM_SUSPEND_MEM: |
| mx5_cpu_lp_set(STOP_POWER_OFF); |
| break; |
| case PM_SUSPEND_STANDBY: |
| /* DEFAULT_IDLE_STATE already configured */ |
| break; |
| default: |
| return -EINVAL; |
| } |
| |
| if (state == PM_SUSPEND_MEM) { |
| local_flush_tlb_all(); |
| flush_cache_all(); |
| |
| /*clear the EMPGC0/1 bits */ |
| __raw_writel(0, MXC_SRPG_EMPGC0_SRPGCR); |
| __raw_writel(0, MXC_SRPG_EMPGC1_SRPGCR); |
| } |
| cpu_do_idle(); |
| |
| /* return registers to default idle state */ |
| mx5_cpu_lp_set(IMX5_DEFAULT_CPU_IDLE_STATE); |
| return 0; |
| } |
| |
| static int mx5_pm_valid(suspend_state_t state) |
| { |
| return (state > PM_SUSPEND_ON && state <= PM_SUSPEND_MAX); |
| } |
| |
| static const struct platform_suspend_ops mx5_suspend_ops = { |
| .valid = mx5_pm_valid, |
| .enter = mx5_suspend_enter, |
| }; |
| |
| static inline int imx5_cpu_do_idle(void) |
| { |
| int ret = tzic_enable_wake(); |
| |
| if (likely(!ret)) |
| cpu_do_idle(); |
| |
| return ret; |
| } |
| |
| static void imx5_pm_idle(void) |
| { |
| imx5_cpu_do_idle(); |
| } |
| |
| static int imx5_cpuidle_enter(struct cpuidle_device *dev, |
| struct cpuidle_driver *drv, int idx) |
| { |
| int ret; |
| |
| ret = imx5_cpu_do_idle(); |
| if (ret < 0) |
| return ret; |
| |
| return idx; |
| } |
| |
| static struct cpuidle_driver imx5_cpuidle_driver = { |
| .name = "imx5_cpuidle", |
| .owner = THIS_MODULE, |
| .en_core_tk_irqen = 1, |
| .states[0] = { |
| .enter = imx5_cpuidle_enter, |
| .exit_latency = 2, |
| .target_residency = 1, |
| .flags = CPUIDLE_FLAG_TIME_VALID, |
| .name = "IMX5 SRPG", |
| .desc = "CPU state retained,powered off", |
| }, |
| .state_count = 1, |
| }; |
| |
| static int __init imx5_pm_common_init(void) |
| { |
| int ret; |
| struct clk *gpc_dvfs_clk = clk_get(NULL, "gpc_dvfs"); |
| |
| if (IS_ERR(gpc_dvfs_clk)) |
| return PTR_ERR(gpc_dvfs_clk); |
| |
| ret = clk_prepare_enable(gpc_dvfs_clk); |
| if (ret) |
| return ret; |
| |
| arm_pm_idle = imx5_pm_idle; |
| |
| /* Set the registers to the default cpu idle state. */ |
| mx5_cpu_lp_set(IMX5_DEFAULT_CPU_IDLE_STATE); |
| |
| imx_cpuidle_init(&imx5_cpuidle_driver); |
| return 0; |
| } |
| |
| void __init imx51_pm_init(void) |
| { |
| int ret = imx5_pm_common_init(); |
| if (!ret) |
| suspend_set_ops(&mx5_suspend_ops); |
| } |
| |
| void __init imx53_pm_init(void) |
| { |
| imx5_pm_common_init(); |
| } |