[PATCH] sd: read-only switch
Support for the read-only switch on SD cards which must be enforced by the
host.
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>
Cc: Russell King <rmk@arm.linux.org.uk>
Cc: David Brownell <david-b@pacbell.net>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
diff --git a/drivers/mmc/mmc.c b/drivers/mmc/mmc.c
index 294961a..725c6ad 100644
--- a/drivers/mmc/mmc.c
+++ b/drivers/mmc/mmc.c
@@ -413,8 +413,7 @@
card->cid.month = UNSTUFF_BITS(resp, 8, 4);
card->cid.year += 2000; /* SD cards year offset */
- }
- else {
+ } else {
/*
* The selection of the format here is based upon published
* specs from sandisk and from what people have reported.
@@ -494,8 +493,7 @@
csd->capacity = (1 + m) << (e + 2);
csd->read_blkbits = UNSTUFF_BITS(resp, 80, 4);
- }
- else {
+ } else {
/*
* We only understand CSD structure v1.1 and v1.2.
* v1.2 has extra information in bits 15, 11 and 10.
@@ -738,10 +736,20 @@
err = mmc_wait_for_cmd(host, &cmd, CMD_RETRIES);
if (err != MMC_ERR_NONE)
mmc_card_set_dead(card);
- else
+ else {
card->rca = cmd.resp[0] >> 16;
- }
- else {
+
+ if (!host->ops->get_ro) {
+ printk(KERN_WARNING "%s: host does not "
+ "support reading read-only "
+ "switch. assuming write-enable.\n",
+ mmc_hostname(host));
+ } else {
+ if (host->ops->get_ro(host))
+ mmc_card_set_readonly(card);
+ }
+ }
+ } else {
cmd.opcode = MMC_SET_RELATIVE_ADDR;
cmd.arg = card->rca << 16;
cmd.flags = MMC_RSP_R1;
@@ -833,24 +841,23 @@
int err;
u32 ocr;
- host->mode = MMC_MODE_MMC;
+ host->mode = MMC_MODE_SD;
mmc_power_up(host);
mmc_idle_cards(host);
- err = mmc_send_op_cond(host, 0, &ocr);
+ err = mmc_send_app_op_cond(host, 0, &ocr);
/*
- * If we fail to detect any cards then try
- * searching for SD cards.
+ * If we fail to detect any SD cards then try
+ * searching for MMC cards.
*/
- if (err != MMC_ERR_NONE)
- {
- err = mmc_send_app_op_cond(host, 0, &ocr);
+ if (err != MMC_ERR_NONE) {
+ host->mode = MMC_MODE_MMC;
+
+ err = mmc_send_op_cond(host, 0, &ocr);
if (err != MMC_ERR_NONE)
return;
-
- host->mode = MMC_MODE_SD;
}
host->ocr = mmc_select_voltage(host, ocr);