clk: qcom: Move cxo/pxo/xo into dt files
Put these clocks into the dt files instead of registering them
from C code. This provides a few benefits. It allows us to
specify the frequency of these clocks at the board level instead
of hard-coding them in the driver. It allows us to insert an RPM
clock in between the consumers of the crystals and the actual
clock. And finally, it helps us transition the GCC driver to use
RPM clocks when that configuration is enabled.
Cc: Georgi Djakov <georgi.djakov@linaro.org>
Signed-off-by: Stephen Boyd <sboyd@codeaurora.org>
diff --git a/drivers/clk/qcom/gcc-msm8974.c b/drivers/clk/qcom/gcc-msm8974.c
index 28abb8f..335952d 100644
--- a/drivers/clk/qcom/gcc-msm8974.c
+++ b/drivers/clk/qcom/gcc-msm8974.c
@@ -2717,7 +2717,7 @@
static int gcc_msm8974_probe(struct platform_device *pdev)
{
- struct clk *clk;
+ int ret;
struct device *dev = &pdev->dev;
bool pro;
const struct of_device_id *id;
@@ -2730,16 +2730,13 @@
if (pro)
msm8974_pro_clock_override();
- /* Temporary until RPM clocks supported */
- clk = clk_register_fixed_rate(dev, "xo", NULL, CLK_IS_ROOT, 19200000);
- if (IS_ERR(clk))
- return PTR_ERR(clk);
+ ret = qcom_cc_register_board_clk(dev, "xo_board", "xo", 19200000);
+ if (ret)
+ return ret;
- /* Should move to DT node? */
- clk = clk_register_fixed_rate(dev, "sleep_clk_src", NULL,
- CLK_IS_ROOT, 32768);
- if (IS_ERR(clk))
- return PTR_ERR(clk);
+ ret = qcom_cc_register_sleep_clk(dev);
+ if (ret)
+ return ret;
return qcom_cc_probe(pdev, &gcc_msm8974_desc);
}