iwlwifi: pcie: apply destination before releasing reset
This allows to use the firmware debugging system even when
the configuration values are set hard coded in the firmware.
Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
diff --git a/drivers/net/wireless/iwlwifi/pcie/trans.c b/drivers/net/wireless/iwlwifi/pcie/trans.c
index 69935aa..f31a941 100644
--- a/drivers/net/wireless/iwlwifi/pcie/trans.c
+++ b/drivers/net/wireless/iwlwifi/pcie/trans.c
@@ -898,6 +898,9 @@
IWL_DEBUG_FW(trans, "working with %s CPU\n",
image->is_dual_cpus ? "Dual" : "Single");
+ if (trans->dbg_dest_tlv)
+ iwl_pcie_apply_destination(trans);
+
/* configure the ucode to be ready to get the secured image */
/* release CPU reset */
iwl_write_prph(trans, RELEASE_CPU_RESET, RELEASE_CPU_RESET_BIT);
@@ -914,9 +917,6 @@
if (ret)
return ret;
- if (trans->dbg_dest_tlv)
- iwl_pcie_apply_destination(trans);
-
/* wait for image verification to complete */
ret = iwl_poll_prph_bit(trans, LMPM_SECURE_BOOT_CPU1_STATUS_ADDR_B0,
LMPM_SECURE_BOOT_STATUS_SUCCESS,