ARM: OMAP2+: GPMC: Support Software ECC scheme via DT
For v3.14 and prior, 1-bit Hamming code ECC via software was the
default choice for some boards e.g. 3430sdp.
Commit ac65caf514ec in v3.15 changed the behaviour
to use 1-bit Hamming code via Hardware using a different ECC layout
i.e. (ROM code layout) than what is used by software ECC.
This ECC layout change causes NAND filesystems created in v3.14
and prior to be unusable in v3.15 and later. So don't mark "sw" scheme
as deperecated and support it.
Signed-off-by: Roger Quadros <rogerq@ti.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>
diff --git a/Documentation/devicetree/bindings/mtd/gpmc-nand.txt b/Documentation/devicetree/bindings/mtd/gpmc-nand.txt
index 65f4f7c..ee654e9 100644
--- a/Documentation/devicetree/bindings/mtd/gpmc-nand.txt
+++ b/Documentation/devicetree/bindings/mtd/gpmc-nand.txt
@@ -22,7 +22,7 @@
width of 8 is assumed.
- ti,nand-ecc-opt: A string setting the ECC layout to use. One of:
- "sw" <deprecated> use "ham1" instead
+ "sw" 1-bit Hamming ecc code via software
"hw" <deprecated> use "ham1" instead
"hw-romcode" <deprecated> use "ham1" instead
"ham1" 1-bit Hamming ecc code
diff --git a/arch/arm/mach-omap2/gpmc.c b/arch/arm/mach-omap2/gpmc.c
index 8bc1338..9f42d54 100644
--- a/arch/arm/mach-omap2/gpmc.c
+++ b/arch/arm/mach-omap2/gpmc.c
@@ -1403,8 +1403,11 @@
pr_err("%s: ti,nand-ecc-opt not found\n", __func__);
return -ENODEV;
}
- if (!strcmp(s, "ham1") || !strcmp(s, "sw") ||
- !strcmp(s, "hw") || !strcmp(s, "hw-romcode"))
+
+ if (!strcmp(s, "sw"))
+ gpmc_nand_data->ecc_opt = OMAP_ECC_HAM1_CODE_SW;
+ else if (!strcmp(s, "ham1") ||
+ !strcmp(s, "hw") || !strcmp(s, "hw-romcode"))
gpmc_nand_data->ecc_opt =
OMAP_ECC_HAM1_CODE_HW;
else if (!strcmp(s, "bch4"))