sh_eth: add R-Car support for real
Commit d0418bb7123f44b23d69ac349eec7daf9103472f (net: sh_eth: Add eth support
for R8A7779 device) was a failed attempt to add support for one of members of
the R-Car SoC family. That's for three reasons: it treated R8A7779 the same
as SH7724 except including quite dirty hack adding ECMR_ELB bit to the mask
in sh_eth_set_rate() while not removing ECMR_RTM bit (despite it's reserved in
R-Car Ether), and it didn't add a new register offset array despite the closest
SH_ETH_REG_FAST_SH4 mapping differs by 0x200 to the offsets all the R-Car Ether
registers have, and also some of the registers in this old mapping don't exist
on R-Car Ether (due to this, SH7724's 'sh_eth_my_cpu_data' structure is not
adequeate for R-Car too). Fix all these shortcomings, restoring the SH7724
related section to its pristine state...
Signed-off-by: Sergei Shtylyov <sergei.shtylyov@cogentembedded.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/renesas/sh_eth.c b/drivers/net/ethernet/renesas/sh_eth.c
index 13abe91..da60405 100644
--- a/drivers/net/ethernet/renesas/sh_eth.c
+++ b/drivers/net/ethernet/renesas/sh_eth.c
@@ -2,7 +2,8 @@
* SuperH Ethernet device driver
*
* Copyright (C) 2006-2012 Nobuhiro Iwamatsu
- * Copyright (C) 2008-2012 Renesas Solutions Corp.
+ * Copyright (C) 2008-2013 Renesas Solutions Corp.
+ * Copyright (C) 2013 Cogent Embedded, Inc.
*
* This program is free software; you can redistribute it and/or modify it
* under the terms and conditions of the GNU General Public License,
@@ -147,6 +148,51 @@
[FWALCR1] = 0x00b4,
};
+static const u16 sh_eth_offset_fast_rcar[SH_ETH_MAX_REGISTER_OFFSET] = {
+ [ECMR] = 0x0300,
+ [RFLR] = 0x0308,
+ [ECSR] = 0x0310,
+ [ECSIPR] = 0x0318,
+ [PIR] = 0x0320,
+ [PSR] = 0x0328,
+ [RDMLR] = 0x0340,
+ [IPGR] = 0x0350,
+ [APR] = 0x0354,
+ [MPR] = 0x0358,
+ [RFCF] = 0x0360,
+ [TPAUSER] = 0x0364,
+ [TPAUSECR] = 0x0368,
+ [MAHR] = 0x03c0,
+ [MALR] = 0x03c8,
+ [TROCR] = 0x03d0,
+ [CDCR] = 0x03d4,
+ [LCCR] = 0x03d8,
+ [CNDCR] = 0x03dc,
+ [CEFCR] = 0x03e4,
+ [FRECR] = 0x03e8,
+ [TSFRCR] = 0x03ec,
+ [TLFRCR] = 0x03f0,
+ [RFCR] = 0x03f4,
+ [MAFCR] = 0x03f8,
+
+ [EDMR] = 0x0200,
+ [EDTRR] = 0x0208,
+ [EDRRR] = 0x0210,
+ [TDLAR] = 0x0218,
+ [RDLAR] = 0x0220,
+ [EESR] = 0x0228,
+ [EESIPR] = 0x0230,
+ [TRSCER] = 0x0238,
+ [RMFCR] = 0x0240,
+ [TFTR] = 0x0248,
+ [FDR] = 0x0250,
+ [RMCR] = 0x0258,
+ [TFUCR] = 0x0264,
+ [RFOCR] = 0x0268,
+ [FCFTR] = 0x0270,
+ [TRIMD] = 0x027c,
+};
+
static const u16 sh_eth_offset_fast_sh4[SH_ETH_MAX_REGISTER_OFFSET] = {
[ECMR] = 0x0100,
[RFLR] = 0x0108,
@@ -296,7 +342,7 @@
#endif
/* There is CPU dependent code */
-#if defined(CONFIG_CPU_SUBTYPE_SH7724) || defined(CONFIG_ARCH_R8A7779)
+#if defined(CONFIG_ARCH_R8A7779)
#define SH_ETH_RESET_DEFAULT 1
static void sh_eth_set_duplex(struct net_device *ndev)
{
@@ -311,18 +357,60 @@
static void sh_eth_set_rate(struct net_device *ndev)
{
struct sh_eth_private *mdp = netdev_priv(ndev);
- unsigned int bits = ECMR_RTM;
-
-#if defined(CONFIG_ARCH_R8A7779)
- bits |= ECMR_ELB;
-#endif
switch (mdp->speed) {
case 10: /* 10BASE */
- sh_eth_write(ndev, sh_eth_read(ndev, ECMR) & ~bits, ECMR);
+ sh_eth_write(ndev, sh_eth_read(ndev, ECMR) & ~ECMR_ELB, ECMR);
break;
case 100:/* 100BASE */
- sh_eth_write(ndev, sh_eth_read(ndev, ECMR) | bits, ECMR);
+ sh_eth_write(ndev, sh_eth_read(ndev, ECMR) | ECMR_ELB, ECMR);
+ break;
+ default:
+ break;
+ }
+}
+
+/* R8A7779 */
+static struct sh_eth_cpu_data sh_eth_my_cpu_data = {
+ .set_duplex = sh_eth_set_duplex,
+ .set_rate = sh_eth_set_rate,
+
+ .ecsr_value = ECSR_PSRTO | ECSR_LCHNG | ECSR_ICD,
+ .ecsipr_value = ECSIPR_PSRTOIP | ECSIPR_LCHNGIP | ECSIPR_ICDIP,
+ .eesipr_value = 0x01ff009f,
+
+ .tx_check = EESR_FTC | EESR_CND | EESR_DLC | EESR_CD | EESR_RTO,
+ .eesr_err_check = EESR_TWB | EESR_TABT | EESR_RABT | EESR_RDE |
+ EESR_RFRMER | EESR_TFE | EESR_TDE | EESR_ECI,
+ .tx_error_check = EESR_TWB | EESR_TABT | EESR_TDE | EESR_TFE,
+
+ .apr = 1,
+ .mpr = 1,
+ .tpauser = 1,
+ .hw_swap = 1,
+};
+#elif defined(CONFIG_CPU_SUBTYPE_SH7724)
+#define SH_ETH_RESET_DEFAULT 1
+static void sh_eth_set_duplex(struct net_device *ndev)
+{
+ struct sh_eth_private *mdp = netdev_priv(ndev);
+
+ if (mdp->duplex) /* Full */
+ sh_eth_write(ndev, sh_eth_read(ndev, ECMR) | ECMR_DM, ECMR);
+ else /* Half */
+ sh_eth_write(ndev, sh_eth_read(ndev, ECMR) & ~ECMR_DM, ECMR);
+}
+
+static void sh_eth_set_rate(struct net_device *ndev)
+{
+ struct sh_eth_private *mdp = netdev_priv(ndev);
+
+ switch (mdp->speed) {
+ case 10: /* 10BASE */
+ sh_eth_write(ndev, sh_eth_read(ndev, ECMR) & ~ECMR_RTM, ECMR);
+ break;
+ case 100:/* 100BASE */
+ sh_eth_write(ndev, sh_eth_read(ndev, ECMR) | ECMR_RTM, ECMR);
break;
default:
break;
@@ -2521,6 +2609,9 @@
case SH_ETH_REG_GIGABIT:
reg_offset = sh_eth_offset_gigabit;
break;
+ case SH_ETH_REG_FAST_RCAR:
+ reg_offset = sh_eth_offset_fast_rcar;
+ break;
case SH_ETH_REG_FAST_SH4:
reg_offset = sh_eth_offset_fast_sh4;
break;