[PATCH] ohci1394, sbp2: fix "scsi_add_device failed" with PL-3507 based devices
Re-enable posted writes for status FIFO.
Besides bringing back a very minor bandwidth tweak from Linux 2.6.15.x
and older, this also fixes an interoperability regression since 2.6.16:
http://bugzilla.kernel.org/show_bug.cgi?id=6356
(sbp2: scsi_add_device failed. IEEE1394 HD is not working anymore.)
Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>
Tested-by: Vanei Heidemann <linux@javanei.com.br>
Tested-by: Martin Putzlocher <mputzi@gmx.de> (chip type unconfirmed)
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
diff --git a/drivers/ieee1394/ohci1394.c b/drivers/ieee1394/ohci1394.c
index 1922287..11f1377 100644
--- a/drivers/ieee1394/ohci1394.c
+++ b/drivers/ieee1394/ohci1394.c
@@ -553,7 +553,7 @@
* register content.
* To actually enable physical responses is the job of our interrupt
* handler which programs the physical request filter. */
- reg_write(ohci, OHCI1394_PhyUpperBound, 0xffff0000);
+ reg_write(ohci, OHCI1394_PhyUpperBound, 0x01000000);
DBGMSG("physUpperBoundOffset=%08x",
reg_read(ohci, OHCI1394_PhyUpperBound));
diff --git a/drivers/ieee1394/sbp2.c b/drivers/ieee1394/sbp2.c
index 7355580..8a23fb5 100644
--- a/drivers/ieee1394/sbp2.c
+++ b/drivers/ieee1394/sbp2.c
@@ -835,11 +835,16 @@
/* Register the status FIFO address range. We could use the same FIFO
* for targets at different nodes. However we need different FIFOs per
- * target in order to support multi-unit devices. */
+ * target in order to support multi-unit devices.
+ * The FIFO is located out of the local host controller's physical range
+ * but, if possible, within the posted write area. Status writes will
+ * then be performed as unified transactions. This slightly reduces
+ * bandwidth usage, and some Prolific based devices seem to require it.
+ */
scsi_id->status_fifo_addr = hpsb_allocate_and_register_addrspace(
&sbp2_highlevel, ud->ne->host, &sbp2_ops,
sizeof(struct sbp2_status_block), sizeof(quadlet_t),
- ~0ULL, ~0ULL);
+ 0x010000000000ULL, CSR1212_ALL_SPACE_END);
if (!scsi_id->status_fifo_addr) {
SBP2_ERR("failed to allocate status FIFO address range");
goto failed_alloc;