gpio: add interrupt handling capability to max732x
Most of the GPIO expanders supported by the max732x driver have interrupt
generation capability by reporting changes on input pins through an INT#
pin. This patch implements the irq_chip functionnality (edge detection
only).
Signed-off-by: Marc Zyngier <maz@misterjones.org>
Cc: Eric Miao <eric.y.miao@gmail.com>
Cc: Jebediah Huang <jebediah.huang@gmail.com>
Cc: David Brownell <david-b@pacbell.net>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/drivers/gpio/Kconfig b/drivers/gpio/Kconfig
index fee678f..1aa63a2 100644
--- a/drivers/gpio/Kconfig
+++ b/drivers/gpio/Kconfig
@@ -139,6 +139,13 @@
Board setup code must specify the model to use, and the start
number for these GPIOs.
+config GPIO_MAX732X_IRQ
+ bool "Interrupt controller support for MAX732x"
+ depends on GPIO_MAX732X=y && GENERIC_HARDIRQS
+ help
+ Say yes here to enable the max732x to be used as an interrupt
+ controller. It requires the driver to be built in the kernel.
+
config GPIO_PCA953X
tristate "PCA953x, PCA955x, TCA64xx, and MAX7310 I/O ports"
depends on I2C