stmmac: hardware TX COE doesn't work when force_thresh_dma_mode is set
Commit f748be531d70 ("stmmac: support new GMAC4") reverted a previous fix
by mistake. This commit re-applies said fix:
commit dec2165ff38a99f937fe61875d102c6c8596c815
Author: Sonic Zhang <sonic.zhang@analog.com>
Date: Thu Jan 22 14:55:57 2015 +0800
stmmac: hardware TX COE doesn't work when force_thresh_dma_mode is set
Clear the TX COE bit when force_thresh_dma_mode is set even hardware
dma capability says support.
Tested on BF609.
Signed-off-by: Sonic Zhang <sonic.zhang@analog.com>
Acked-by: Giuseppe Cavallaro <peppe.cavallaro@st.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Tested on LPC4350 Hitex board.
Fixes: f748be531d70 ("stmmac: support new GMAC4")
Signed-off-by: Ezequiel Garcia <ezequiel@vanguardiasur.com.ar>
Tested-by: Joachim Eastwood <manabian@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
index fd5ab7b..eac45d0 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
@@ -3131,7 +3131,12 @@
priv->plat->enh_desc = priv->dma_cap.enh_desc;
priv->plat->pmt = priv->dma_cap.pmt_remote_wake_up;
- priv->plat->tx_coe = priv->dma_cap.tx_coe;
+ /* TXCOE doesn't work in thresh DMA mode */
+ if (priv->plat->force_thresh_dma_mode)
+ priv->plat->tx_coe = 0;
+ else
+ priv->plat->tx_coe = priv->dma_cap.tx_coe;
+
/* In case of GMAC4 rx_coe is from HW cap register. */
priv->plat->rx_coe = priv->dma_cap.rx_coe;