ah6/esp6: set transport header correctly for IPsec tunnel mode.
IPsec tunnel does not set ECN field to CE in inner header when
the ECN field in the outer header is CE, and the ECN field in
the inner header is ECT(0) or ECT(1).
The cause is ipip6_hdr() does not return the correct address of
inner header since skb->transport-header is not the inner header
after esp6_input_done2(), or ah6_input().
Signed-off-by: Li RongQing <roy.qing.li@gmail.com>
Signed-off-by: Steffen Klassert <steffen.klassert@secunet.com>
diff --git a/net/ipv6/esp6.c b/net/ipv6/esp6.c
index 282f372..40ffd72 100644
--- a/net/ipv6/esp6.c
+++ b/net/ipv6/esp6.c
@@ -300,7 +300,10 @@
pskb_trim(skb, skb->len - alen - padlen - 2);
__skb_pull(skb, hlen);
- skb_set_transport_header(skb, -hdr_len);
+ if (x->props.mode == XFRM_MODE_TUNNEL)
+ skb_reset_transport_header(skb);
+ else
+ skb_set_transport_header(skb, -hdr_len);
err = nexthdr[1];