USB: f81232.c: remove dbg() usage
dbg() is a usb-serial specific macro. This patch converts
the f81232.c driver to use dev_dbg() instead to tie into the
dynamic debug infrastructure.
CC: Alan Stern <stern@rowland.harvard.edu>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/usb/serial/f81232.c b/drivers/usb/serial/f81232.c
index 5a247ff..499b15f 100644
--- a/drivers/usb/serial/f81232.c
+++ b/drivers/usb/serial/f81232.c
@@ -76,12 +76,12 @@
case -ENOENT:
case -ESHUTDOWN:
/* this urb is terminated, clean up */
- dbg("%s - urb shutting down with status: %d", __func__,
- status);
+ dev_dbg(&port->dev, "%s - urb shutting down with status: %d\n",
+ __func__, status);
return;
default:
- dbg("%s - nonzero urb status received: %d", __func__,
- status);
+ dev_dbg(&port->dev, "%s - nonzero urb status received: %d\n",
+ __func__, status);
goto exit;
}
@@ -131,7 +131,7 @@
tty_flag = TTY_PARITY;
else if (line_status & UART_FRAME_ERROR)
tty_flag = TTY_FRAME;
- dbg("%s - tty_flag = %d", __func__, tty_flag);
+ dev_dbg(&port->dev, "%s - tty_flag = %d\n", __func__, tty_flag);
/* overrun is special, not associated with a char */
if (line_status & UART_OVERRUN_ERROR)
@@ -290,7 +290,9 @@
{
struct serial_struct ser;
struct usb_serial_port *port = tty->driver_data;
- dbg("%s (%d) cmd = 0x%04x", __func__, port->number, cmd);
+
+ dev_dbg(&port->dev, "%s (%d) cmd = 0x%04x\n", __func__,
+ port->number, cmd);
switch (cmd) {
case TIOCGSERIAL:
@@ -306,10 +308,12 @@
return 0;
case TIOCMIWAIT:
- dbg("%s (%d) TIOCMIWAIT", __func__, port->number);
+ dev_dbg(&port->dev, "%s (%d) TIOCMIWAIT\n", __func__,
+ port->number);
return wait_modem_info(port, arg);
default:
- dbg("%s not supported = 0x%04x", __func__, cmd);
+ dev_dbg(&port->dev, "%s not supported = 0x%04x\n",
+ __func__, cmd);
break;
}
return -ENOIOCTLCMD;