Merge branch 'dt_fixed_phy'

Thomas Petazzoni says:

====================
Add DT support for fixed PHYs

Here is a fourth version of the patch set that adds a Device Tree
binding and the related code to support fixed PHYs. I'm hoping to get
this merged in 3.16.

Changes since v3:

 * Rebased on top of v3.15-rc5

 * In patch "net: phy: decouple PHY id and PHY address in fixed PHY
   driver", changed the PHY ID of fixed PHYs from 0xdeadbeef to 0x0,
   as suggested by Grant Likely.

 * Fixed the !CONFIG_PHY_FIXED case in patch "net: phy: extend fixed
   driver with fixed_phy_register()". Noticed by Florian Fainelli.

 * Added Acked-by from Grant Likely and Florian Fainelli on patch
   "net: phy: extend fixed driver with fixed_phy_register()".

 * Reworked the new fixed-link DT binding to be just a sub-node of the
   Ethernet MAC node, and not a node referenced by the 'phy'
   property. This was requested by Grant Likely.

 * Reworked the code implementing the new DT binding to also make it
   accept the old, single property based, DT binding.

 * Added a patch that actually uses the new fixed link DT binding for
   the Armada XP Matrix board.

Changes since v2:

 * Rebased on top of v3.14-rc1, and re-tested on hardware.

 * Removed the RFC tag, since there seems to be some real interest in
   this feature, and the code has gone through several iterations
   already.

 * The error handling in fixed_phy_register() has been fixed.

Changes since v1:

 * Instead of using a 'fixed-link' property inside the Ethernet device
   DT node, with a fairly cryptic succession of integer values, we now
   use a PHY subnode under the Ethernet device DT node, with explicit
   properties to configure the duplex, speed, pause and other PHY
   properties.

 * The PHY address is automatically allocated by the kernel and no
   longer visible in the Device Tree binding.

 * The PHY device is created directly when the network driver calls
   of_phy_connect_fixed_link(), and associated to the PHY DT node,
   which allows the existing of_phy_connect() function to work,
   without the need to use the deprecated of_phy_connect_fixed_link().

Posts of previous versions:

  RFCv1:   http://www.spinics.net/lists/netdev/msg243253.html
  RFCv2:   http://lists.infradead.org/pipermail/linux-arm-kernel/2013-September/196919.html
  PATCHv3: http://www.spinics.net/lists/netdev/msg273117.html
====================

Signed-off-by: David S. Miller <davem@davemloft.net>