hwmon: (ina2xx) Add ina231 compatible string
Add support for "ina231" as compatible string, and update
Documentation and Kconfig accordingly.
Tested with the Exynos5422-based odroid-xu3 board which has on-board
INA231 sensors.
Signed-off-by: Kevin Hilman <khilman@linaro.org>
Signed-off-by: Guenter Roeck <linux@roeck-us.net>
diff --git a/Documentation/hwmon/ina2xx b/Documentation/hwmon/ina2xx
index 450e3cc..cfd31d9 100644
--- a/Documentation/hwmon/ina2xx
+++ b/Documentation/hwmon/ina2xx
@@ -26,6 +26,12 @@
Datasheet: Publicly available at the Texas Instruments website
http://www.ti.com/
+ * Texas Instruments INA231
+ Prefix: 'ina231'
+ Addresses: I2C 0x40 - 0x4f
+ Datasheet: Publicly available at the Texas Instruments website
+ http://www.ti.com/
+
Author: Lothar Felten <l-felten@ti.com>
Description
@@ -41,8 +47,9 @@
The INA226 is a current shunt and power monitor with an I2C interface.
The INA226 monitors both a shunt voltage drop and bus supply voltage.
-The INA230 is a high or low side current shunt and power monitor with an I2C
-interface. The INA230 monitors both a shunt voltage drop and bus supply voltage.
+INA230 and INA231 are high or low side current shunt and power monitors
+with an I2C interface. The chips monitor both a shunt voltage drop and
+bus supply voltage.
The shunt value in micro-ohms can be set via platform data or device tree at
compile-time or via the shunt_resistor attribute in sysfs at run-time. Please