| # |
| # Qualcomm network device configuration |
| # |
| |
| config NET_VENDOR_QUALCOMM |
| bool "Qualcomm devices" |
| default y |
| ---help--- |
| If you have a network (Ethernet) card belonging to this class, say Y. |
| |
| Note that the answer to this question doesn't directly affect the |
| kernel: saying N will just cause the configurator to skip all |
| the questions about Qualcomm cards. If you say Y, you will be asked |
| for your specific card in the following questions. |
| |
| if NET_VENDOR_QUALCOMM |
| |
| config QCA7000 |
| tristate |
| help |
| This enables support for the Qualcomm Atheros QCA7000. |
| |
| config QCA7000_SPI |
| tristate "Qualcomm Atheros QCA7000 SPI support" |
| select QCA7000 |
| depends on SPI_MASTER && OF |
| ---help--- |
| This SPI protocol driver supports the Qualcomm Atheros QCA7000. |
| |
| To compile this driver as a module, choose M here. The module |
| will be called qcaspi. |
| |
| config QCA7000_UART |
| tristate "Qualcomm Atheros QCA7000 UART support" |
| select QCA7000 |
| depends on SERIAL_DEV_BUS && OF |
| ---help--- |
| This UART protocol driver supports the Qualcomm Atheros QCA7000. |
| |
| Currently the driver assumes these device UART settings: |
| Data bits: 8 |
| Parity: None |
| Stop bits: 1 |
| Flow control: None |
| |
| To compile this driver as a module, choose M here. The module |
| will be called qcauart. |
| |
| config QCOM_EMAC |
| tristate "Qualcomm Technologies, Inc. EMAC Gigabit Ethernet support" |
| depends on HAS_DMA && HAS_IOMEM |
| select CRC32 |
| select PHYLIB |
| ---help--- |
| This driver supports the Qualcomm Technologies, Inc. Gigabit |
| Ethernet Media Access Controller (EMAC). The controller |
| supports IEEE 802.3-2002, half-duplex mode at 10/100 Mb/s, |
| full-duplex mode at 10/100/1000Mb/s, Wake On LAN (WOL) for |
| low power, Receive-Side Scaling (RSS), and IEEE 1588-2008 |
| Precision Clock Synchronization Protocol. |
| |
| endif # NET_VENDOR_QUALCOMM |