ftrace: Add arm64 support to recordmcount
Recordmcount utility under scripts is run, after compiling each object,
to find out all the locations of calling _mcount() and put them into
specific seciton named __mcount_loc.
Then linker collects all such information into a table in the kernel image
(between __start_mcount_loc and __stop_mcount_loc) for later use by ftrace.
This patch adds arm64 specific definitions to identify such locations.
There are two types of implementation, C and Perl. On arm64, only C version
is used to build the kernel now that CONFIG_HAVE_C_RECORDMCOUNT is on.
But Perl version is also maintained.
This patch also contains a workaround just in case where a header file,
elf.h, on host machine doesn't have definitions of EM_AARCH64 nor
R_AARCH64_ABS64. Without them, compiling C version of recordmcount will
fail.
Acked-by: Will Deacon <will.deacon@arm.com>
Signed-off-by: AKASHI Takahiro <takahiro.akashi@linaro.org>
Signed-off-by: Will Deacon <will.deacon@arm.com>
diff --git a/scripts/recordmcount.pl b/scripts/recordmcount.pl
index 91280b8..397b6b8 100755
--- a/scripts/recordmcount.pl
+++ b/scripts/recordmcount.pl
@@ -279,6 +279,11 @@
$mcount_regex = "^\\s*([0-9a-fA-F]+):\\s*R_ARM_(CALL|PC24|THM_CALL)" .
"\\s+(__gnu_mcount_nc|mcount)\$";
+} elsif ($arch eq "arm64") {
+ $alignment = 3;
+ $section_type = '%progbits';
+ $mcount_regex = "^\\s*([0-9a-fA-F]+):\\s*R_AARCH64_CALL26\\s+_mcount\$";
+ $type = ".quad";
} elsif ($arch eq "ia64") {
$mcount_regex = "^\\s*([0-9a-fA-F]+):.*\\s_mcount\$";
$type = "data8";