mtd: nand: do not ignore all ECC errors
There are a few reasons not to ignore ECC errors here.
First, mtd->read_oob is being called in raw mode, so there should be no
error correction in the first place.
Second, if we change this such that there *is* error correction in this
function, then we will want to pass the error message upward.
In fact, the code I introduced to "ignore ECC errors" would have been
better if it had just placed this test down in `scan_block_full()' in
the first place. We would like to ignore ECC errors when we are simply
checking for bad block markers (e.g., factory marked), but we may not
want to ignore ECC errors when scanning OOB for a flash-based BBT
pattern (in `scan_read_raw()'; note that the return codes from
`scan_read_raw()' are not actually handled yet).
Signed-off-by: Brian Norris <computersforpeace@gmail.com>
Signed-off-by: Artem Bityutskiy <artem.bityutskiy@intel.com>
diff --git a/drivers/mtd/nand/nand_bbt.c b/drivers/mtd/nand/nand_bbt.c
index cbf9b69..fcfaf06 100644
--- a/drivers/mtd/nand/nand_bbt.c
+++ b/drivers/mtd/nand/nand_bbt.c
@@ -313,8 +313,7 @@
res = mtd->read_oob(mtd, offs, &ops);
- /* Ignore ECC errors when checking for BBM */
- if (res && res != -EUCLEAN && res != -EBADMSG)
+ if (res)
return res;
buf += mtd->oobsize + mtd->writesize;
@@ -400,7 +399,8 @@
int ret, j;
ret = scan_read_raw_oob(mtd, buf, offs, readlen);
- if (ret)
+ /* Ignore ECC errors when checking for BBM */
+ if (ret && ret != -EUCLEAN && ret != -EBADMSG)
return ret;
for (j = 0; j < len; j++, buf += scanlen) {