arc_emac: remove custom "max-speed" parsing code
The ARC emac driver was the only in-tree to parse a PHY device
'max-speed' property but yet failed to do it correctly because
'max-speed' is supposed to set a PHY device supported features, not the
advertising features as it was done.
Now that of_mdiobus_register() takes care of doing that, remove the
custom 'max-speed' parsing code.
Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/arc/emac.h b/drivers/net/ethernet/arc/emac.h
index dc08678..928fac6 100644
--- a/drivers/net/ethernet/arc/emac.h
+++ b/drivers/net/ethernet/arc/emac.h
@@ -122,7 +122,6 @@
* @link: PHY's last seen link state.
* @duplex: PHY's last set duplex mode.
* @speed: PHY's last set speed.
- * @max_speed: Maximum supported by current system network data-rate.
*/
struct arc_emac_priv {
/* Devices */
@@ -152,7 +151,6 @@
unsigned int link;
unsigned int duplex;
unsigned int speed;
- unsigned int max_speed;
};
/**
diff --git a/drivers/net/ethernet/arc/emac_main.c b/drivers/net/ethernet/arc/emac_main.c
index b2ffad1..eedf2a5 100644
--- a/drivers/net/ethernet/arc/emac_main.c
+++ b/drivers/net/ethernet/arc/emac_main.c
@@ -381,17 +381,7 @@
phy_dev->autoneg = AUTONEG_ENABLE;
phy_dev->speed = 0;
phy_dev->duplex = 0;
- phy_dev->advertising = phy_dev->supported;
-
- if (priv->max_speed > 100) {
- phy_dev->advertising &= PHY_GBIT_FEATURES;
- } else if (priv->max_speed <= 100) {
- phy_dev->advertising &= PHY_BASIC_FEATURES;
- if (priv->max_speed <= 10) {
- phy_dev->advertising &= ~SUPPORTED_100baseT_Half;
- phy_dev->advertising &= ~SUPPORTED_100baseT_Full;
- }
- }
+ phy_dev->advertising &= phy_dev->supported;
priv->last_rx_bd = 0;
@@ -704,14 +694,6 @@
/* Set poll rate so that it polls every 1 ms */
arc_reg_set(priv, R_POLLRATE, clock_frequency / 1000000);
- /* Get max speed of operation from device tree */
- if (of_property_read_u32(pdev->dev.of_node, "max-speed",
- &priv->max_speed)) {
- dev_err(&pdev->dev, "failed to retrieve <max-speed> from device tree\n");
- err = -EINVAL;
- goto out;
- }
-
ndev->irq = irq;
dev_info(&pdev->dev, "IRQ is %d\n", ndev->irq);