| * Allwinner A1X Pin Controller |
| |
| The pins controlled by sunXi pin controller are organized in banks, |
| each bank has 32 pins. Each pin has 7 multiplexing functions, with |
| the first two functions being GPIO in and out. The configuration on |
| the pins includes drive strength and pull-up. |
| |
| Required properties: |
| - compatible: Should be one of the followings (depending on you SoC): |
| "allwinner,sun4i-a10-pinctrl" |
| "allwinner,sun5i-a10s-pinctrl" |
| "allwinner,sun5i-a13-pinctrl" |
| "allwinner,sun6i-a31-pinctrl" |
| "allwinner,sun6i-a31-r-pinctrl" |
| "allwinner,sun7i-a20-pinctrl" |
| "allwinner,sun8i-a23-pinctrl" |
| "allwinner,sun8i-a23-r-pinctrl" |
| - reg: Should contain the register physical address and length for the |
| pin controller. |
| |
| Please refer to pinctrl-bindings.txt in this directory for details of the |
| common pinctrl bindings used by client devices. |
| |
| A pinctrl node should contain at least one subnodes representing the |
| pinctrl groups available on the machine. Each subnode will list the |
| pins it needs, and how they should be configured, with regard to muxer |
| configuration, drive strength and pullups. If one of these options is |
| not set, its actual value will be unspecified. |
| |
| Required subnode-properties: |
| |
| - allwinner,pins: List of strings containing the pin name. |
| - allwinner,function: Function to mux the pins listed above to. |
| |
| Optional subnode-properties: |
| - allwinner,drive: Integer. Represents the current sent to the pin |
| 0: 10 mA |
| 1: 20 mA |
| 2: 30 mA |
| 3: 40 mA |
| - allwinner,pull: Integer. |
| 0: No resistor |
| 1: Pull-up resistor |
| 2: Pull-down resistor |
| |
| Examples: |
| |
| pinctrl@01c20800 { |
| compatible = "allwinner,sun5i-a13-pinctrl"; |
| reg = <0x01c20800 0x400>; |
| #address-cells = <1>; |
| #size-cells = <0>; |
| |
| uart1_pins_a: uart1@0 { |
| allwinner,pins = "PE10", "PE11"; |
| allwinner,function = "uart1"; |
| allwinner,drive = <0>; |
| allwinner,pull = <0>; |
| }; |
| |
| uart1_pins_b: uart1@1 { |
| allwinner,pins = "PG3", "PG4"; |
| allwinner,function = "uart1"; |
| allwinner,drive = <0>; |
| allwinner,pull = <0>; |
| }; |
| }; |