net: dsa: allow enabling and disable switch ports
Whenever a per-port network device is used/unused, invoke the switch
driver port_enable/port_disable callbacks to allow saving as much power
as possible by disabling unused parts of the switch (RX/TX logic, memory
arrays, PHYs...). We supply a PHY device argument to make sure the
switch driver can act on the PHY device if needed (like putting/taking
the PHY out of deep low power mode).
Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/net/dsa/slave.c b/net/dsa/slave.c
index 4392e98..182d30a 100644
--- a/net/dsa/slave.c
+++ b/net/dsa/slave.c
@@ -62,6 +62,7 @@
{
struct dsa_slave_priv *p = netdev_priv(dev);
struct net_device *master = p->parent->dst->master_netdev;
+ struct dsa_switch *ds = p->parent;
int err;
if (!(master->flags & IFF_UP))
@@ -84,11 +85,20 @@
goto clear_allmulti;
}
+ if (ds->drv->port_enable) {
+ err = ds->drv->port_enable(ds, p->port, p->phy);
+ if (err)
+ goto clear_promisc;
+ }
+
if (p->phy)
phy_start(p->phy);
return 0;
+clear_promisc:
+ if (dev->flags & IFF_PROMISC)
+ dev_set_promiscuity(master, 0);
clear_allmulti:
if (dev->flags & IFF_ALLMULTI)
dev_set_allmulti(master, -1);
@@ -103,6 +113,7 @@
{
struct dsa_slave_priv *p = netdev_priv(dev);
struct net_device *master = p->parent->dst->master_netdev;
+ struct dsa_switch *ds = p->parent;
if (p->phy)
phy_stop(p->phy);
@@ -117,6 +128,9 @@
if (!ether_addr_equal(dev->dev_addr, master->dev_addr))
dev_uc_del(master, dev->dev_addr);
+ if (ds->drv->port_disable)
+ ds->drv->port_disable(ds, p->port, p->phy);
+
return 0;
}