OMAP2/3 board-*.c files: read bootloader configuration earlier
Most board-*.c files read configuration data from the bootloader in
their .init_machine() function. This needs to happen earlier, at some
point before omap2_init_common_hw() is called. This is because a
future patch will use the bootloader serial console port information
to enable the UART clocks earlier, immediately after omap2_clk_init().
This is in turn necessary since otherwise clock tree usecounts on
clocks like dpll4_m2x2_ck will be bogus, which can cause the
currently-active console UART clock to be disabled during boot.
Signed-off-by: Paul Walmsley <paul@pwsan.com>
diff --git a/arch/arm/mach-omap2/board-3430sdp.c b/arch/arm/mach-omap2/board-3430sdp.c
index 7e9b76c..4500e7f 100644
--- a/arch/arm/mach-omap2/board-3430sdp.c
+++ b/arch/arm/mach-omap2/board-3430sdp.c
@@ -167,13 +167,6 @@
&sdp3430_lcd_device,
};
-static void __init omap_3430sdp_init_irq(void)
-{
- omap2_init_common_hw(hyb18m512160af6_sdrc_params, NULL);
- omap_init_irq();
- omap_gpio_init();
-}
-
static struct omap_lcd_config sdp3430_lcd_config __initdata = {
.ctrl_name = "internal",
};
@@ -182,6 +175,15 @@
{ OMAP_TAG_LCD, &sdp3430_lcd_config },
};
+static void __init omap_3430sdp_init_irq(void)
+{
+ omap_board_config = sdp3430_config;
+ omap_board_config_size = ARRAY_SIZE(sdp3430_config);
+ omap2_init_common_hw(hyb18m512160af6_sdrc_params, NULL);
+ omap_init_irq();
+ omap_gpio_init();
+}
+
static int sdp3430_batt_table[] = {
/* 0 C*/
30800, 29500, 28300, 27100,
@@ -477,8 +479,6 @@
{
omap3430_i2c_init();
platform_add_devices(sdp3430_devices, ARRAY_SIZE(sdp3430_devices));
- omap_board_config = sdp3430_config;
- omap_board_config_size = ARRAY_SIZE(sdp3430_config);
if (omap_rev() > OMAP3430_REV_ES1_0)
ts_gpio = SDP3430_TS_GPIO_IRQ_SDPV2;
else