ARM: dts: cfa10036: Change the OLED display to SSD1306
The SSD1307 was used in an early prototype that will never get
distributed. The final board now has a SSD1306 instead, that has its own
power generation unit and thus doesn't need any PWM. The panel attached
to it also changed.
Signed-off-by: Maxime Ripard <maxime.ripard@free-electrons.com>
Signed-off-by: Shawn Guo <shawn.guo@linaro.org>
diff --git a/arch/arm/boot/dts/imx28-cfa10036.dts b/arch/arm/boot/dts/imx28-cfa10036.dts
index 1594694..40488f5a8 100644
--- a/arch/arm/boot/dts/imx28-cfa10036.dts
+++ b/arch/arm/boot/dts/imx28-cfa10036.dts
@@ -58,12 +58,6 @@
};
apbx@80040000 {
- pwm: pwm@80064000 {
- pinctrl-names = "default";
- pinctrl-0 = <&pwm4_pins_a>;
- status = "okay";
- };
-
duart: serial@80074000 {
pinctrl-names = "default";
pinctrl-0 = <&duart_pins_b>;
@@ -75,11 +69,13 @@
pinctrl-0 = <&i2c0_pins_b>;
status = "okay";
- ssd1307: oled@3c {
- compatible = "solomon,ssd1307fb-i2c";
+ ssd1306: oled@3c {
+ compatible = "solomon,ssd1306fb-i2c";
reg = <0x3c>;
- pwms = <&pwm 4 3000>;
reset-gpios = <&gpio2 7 0>;
+ solomon,height = <32>;
+ solomon,width = <128>;
+ solomon,page-offset = <0>;
};
};
};
diff --git a/arch/arm/boot/dts/imx28-cfa10049.dts b/arch/arm/boot/dts/imx28-cfa10049.dts
index 063e620..dfdcd85 100644
--- a/arch/arm/boot/dts/imx28-cfa10049.dts
+++ b/arch/arm/boot/dts/imx28-cfa10049.dts
@@ -166,8 +166,8 @@
apbx@80040000 {
pwm: pwm@80064000 {
- pinctrl-names = "default", "default";
- pinctrl-1 = <&pwm3_pins_b>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&pwm3_pins_b>;
status = "okay";
};