[PATCH] uml: preserve errno in error paths
The poster child for this patch is the third tuntap_user hunk. When an ioctl
fails, it properly closes the opened file descriptor and returns. However,
the close resets errno to 0, and the 'return errno' that follows returns 0
rather than the value that ioctl set. This caused the caller to believe that
the device open succeeded and had opened file descriptor 0, which caused no
end of interesting behavior.
The rest of this patch is a pass through the UML sources looking for places
where errno could be reset before being passed back out. A common culprit is
printk, which could call write, being called before errno is returned.
In some cases, where the code ends up being much smaller, I just deleted the
printk.
There was another case where a caller of run_helper looked at errno after a
failure, rather than the return value of run_helper, which was the errno value
that it wanted.
Signed-off-by: Jeff Dike <jdike@addtoit.com>
Cc: Paolo Giarrusso <blaisorblade@yahoo.it>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
diff --git a/arch/um/drivers/mcast_user.c b/arch/um/drivers/mcast_user.c
index 3fd69067..5db136e 100644
--- a/arch/um/drivers/mcast_user.c
+++ b/arch/um/drivers/mcast_user.c
@@ -54,7 +54,7 @@
struct mcast_data *pri = data;
struct sockaddr_in *sin = pri->mcast_addr;
struct ip_mreq mreq;
- int fd = -EINVAL, yes = 1, err = -EINVAL;;
+ int fd, yes = 1, err = 0;
if ((sin->sin_addr.s_addr == 0) || (sin->sin_port == 0))
@@ -65,13 +65,14 @@
if (fd < 0){
printk("mcast_open : data socket failed, errno = %d\n",
errno);
- fd = -errno;
+ err = -errno;
goto out;
}
if (setsockopt(fd, SOL_SOCKET, SO_REUSEADDR, &yes, sizeof(yes)) < 0) {
printk("mcast_open: SO_REUSEADDR failed, errno = %d\n",
errno);
+ err = -errno;
goto out_close;
}
@@ -80,6 +81,7 @@
sizeof(pri->ttl)) < 0) {
printk("mcast_open: IP_MULTICAST_TTL failed, error = %d\n",
errno);
+ err = -errno;
goto out_close;
}
@@ -87,12 +89,14 @@
if (setsockopt(fd, SOL_IP, IP_MULTICAST_LOOP, &yes, sizeof(yes)) < 0) {
printk("mcast_open: IP_MULTICAST_LOOP failed, error = %d\n",
errno);
+ err = -errno;
goto out_close;
}
/* bind socket to mcast address */
if (bind(fd, (struct sockaddr *) sin, sizeof(*sin)) < 0) {
printk("mcast_open : data bind failed, errno = %d\n", errno);
+ err = -errno;
goto out_close;
}
@@ -107,14 +111,15 @@
"interface on the host.\n");
printk("eth0 should be configured in order to use the "
"multicast transport.\n");
+ err = -errno;
goto out_close;
}
- out:
return fd;
out_close:
os_close_file(fd);
+ out:
return err;
}