Merge branch 'for-linus' into for-next
diff --git a/MAINTAINERS b/MAINTAINERS
index 0beac8a..2431b05 100644
--- a/MAINTAINERS
+++ b/MAINTAINERS
@@ -2743,7 +2743,7 @@
P: Bartlomiej Zolnierkiewicz
M: bzolnier@gmail.com
L: linux-ide@vger.kernel.org
-T: quilt kernel.org/pub/linux/kernel/people/bart/pata-2.6/
+T: git git://git.kernel.org/pub/scm/linux/kernel/git/bart/ide-2.6.git
S: Maintained
F: Documentation/ide/
F: drivers/ide/
diff --git a/drivers/ide/palm_bk3710.c b/drivers/ide/palm_bk3710.c
index d1513b4a..09d813d 100644
--- a/drivers/ide/palm_bk3710.c
+++ b/drivers/ide/palm_bk3710.c
@@ -42,16 +42,9 @@
#define BK3710_BMICP 0x00
#define BK3710_BMISP 0x02
#define BK3710_BMIDTP 0x04
-#define BK3710_BMICS 0x08
-#define BK3710_BMISS 0x0A
-#define BK3710_BMIDTS 0x0C
#define BK3710_IDETIMP 0x40
-#define BK3710_IDETIMS 0x42
-#define BK3710_SIDETIM 0x44
-#define BK3710_SLEWCTL 0x45
#define BK3710_IDESTATUS 0x47
#define BK3710_UDMACTL 0x48
-#define BK3710_UDMATIM 0x4A
#define BK3710_MISCCTL 0x50
#define BK3710_REGSTB 0x54
#define BK3710_REGRCVR 0x58
@@ -63,7 +56,6 @@
#define BK3710_UDMATRP 0x70
#define BK3710_UDMAENV 0x74
#define BK3710_IORDYTMP 0x78
-#define BK3710_IORDYTMS 0x7C
static unsigned ideclk_period; /* in nanoseconds */
@@ -74,12 +66,12 @@
};
static const struct palm_bk3710_udmatiming palm_bk3710_udmatimings[6] = {
- {160, 240 / 2,}, /* UDMA Mode 0 */
- {125, 160 / 2,}, /* UDMA Mode 1 */
- {100, 120 / 2,}, /* UDMA Mode 2 */
- {100, 90 / 2,}, /* UDMA Mode 3 */
- {100, 60 / 2,}, /* UDMA Mode 4 */
- {85, 40 / 2,}, /* UDMA Mode 5 */
+ { 160, 240 / 2 }, /* UDMA Mode 0 */
+ { 125, 160 / 2 }, /* UDMA Mode 1 */
+ { 100, 120 / 2 }, /* UDMA Mode 2 */
+ { 100, 90 / 2 }, /* UDMA Mode 3 */
+ { 100, 60 / 2 }, /* UDMA Mode 4 */
+ { 85, 40 / 2 }, /* UDMA Mode 5 */
};
static void palm_bk3710_setudmamode(void __iomem *base, unsigned int dev,
@@ -96,11 +88,6 @@
trp = DIV_ROUND_UP(palm_bk3710_udmatimings[mode].rptime,
ideclk_period) - 1;
- /* udmatim Register */
- val16 = readw(base + BK3710_UDMATIM) & (dev ? 0xFF0F : 0xFFF0);
- val16 |= (mode << (dev ? 4 : 0));
- writew(val16, base + BK3710_UDMATIM);
-
/* udmastb Ultra DMA Access Strobe Width */
val32 = readl(base + BK3710_UDMASTB) & (0xFF << (dev ? 0 : 8));
val32 |= (t0 << (dev ? 8 : 0));
@@ -161,10 +148,11 @@
u32 val32;
struct ide_timing *t;
+ t = ide_timing_find_mode(XFER_PIO_0 + mode);
+
/* PIO Data Setup */
t0 = DIV_ROUND_UP(cycletime, ideclk_period);
- t2 = DIV_ROUND_UP(ide_timing_find_mode(XFER_PIO_0 + mode)->active,
- ideclk_period);
+ t2 = DIV_ROUND_UP(t->active, ideclk_period);
t2i = t0 - t2 - 1;
t2 -= 1;
@@ -185,7 +173,6 @@
}
/* TASKFILE Setup */
- t = ide_timing_find_mode(XFER_PIO_0 + mode);
t0 = DIV_ROUND_UP(t->cyc8b, ideclk_period);
t2 = DIV_ROUND_UP(t->act8b, ideclk_period);
@@ -234,42 +221,23 @@
static void __devinit palm_bk3710_chipinit(void __iomem *base)
{
/*
- * enable the reset_en of ATA controller so that when ata signals
- * are brought out, by writing into device config. at that
- * time por_n signal should not be 'Z' and have a stable value.
+ * REVISIT: the ATA reset signal needs to be managed through a
+ * GPIO, which means it should come from platform_data. Until
+ * we get and use such information, we have to trust that things
+ * have been reset before we get here.
*/
- writel(0x0300, base + BK3710_MISCCTL);
-
- /* wait for some time and deassert the reset of ATA Device. */
- mdelay(100);
-
- /* Deassert the Reset */
- writel(0x0200, base + BK3710_MISCCTL);
/*
* Program the IDETIMP Register Value based on the following assumptions
*
* (ATA_IDETIMP_IDEEN , ENABLE ) |
- * (ATA_IDETIMP_SLVTIMEN , DISABLE) |
- * (ATA_IDETIMP_RDYSMPL , 70NS) |
- * (ATA_IDETIMP_RDYRCVRY , 50NS) |
- * (ATA_IDETIMP_DMAFTIM1 , PIOCOMP) |
* (ATA_IDETIMP_PREPOST1 , DISABLE) |
- * (ATA_IDETIMP_RDYSEN1 , DISABLE) |
- * (ATA_IDETIMP_PIOFTIM1 , DISABLE) |
- * (ATA_IDETIMP_DMAFTIM0 , PIOCOMP) |
* (ATA_IDETIMP_PREPOST0 , DISABLE) |
- * (ATA_IDETIMP_RDYSEN0 , DISABLE) |
- * (ATA_IDETIMP_PIOFTIM0 , DISABLE)
+ *
+ * DM6446 silicon rev 2.1 and earlier have no observed net benefit
+ * from enabling prefetch/postwrite.
*/
- writew(0xB388, base + BK3710_IDETIMP);
-
- /*
- * Configure SIDETIM Register
- * (ATA_SIDETIM_RDYSMPS1 ,120NS ) |
- * (ATA_SIDETIM_RDYRCYS1 ,120NS )
- */
- writeb(0, base + BK3710_SIDETIM);
+ writew(BIT(15), base + BK3710_IDETIMP);
/*
* UDMACTL Ultra-ATA DMA Control
@@ -281,11 +249,11 @@
/*
* MISCCTL Miscellaneous Conrol Register
- * (ATA_MISCCTL_RSTMODEP , 1) |
- * (ATA_MISCCTL_RESETP , 0) |
+ * (ATA_MISCCTL_HWNHLD1P , 1 cycle)
+ * (ATA_MISCCTL_HWNHLD0P , 1 cycle)
* (ATA_MISCCTL_TIMORIDE , 1)
*/
- writel(0x201, base + BK3710_MISCCTL);
+ writel(0x001, base + BK3710_MISCCTL);
/*
* IORDYTMP IORDY Timer for Primary Register
@@ -355,10 +323,9 @@
clk_enable(clk);
rate = clk_get_rate(clk);
- ideclk_period = 1000000000UL / rate;
- /* Register the IDE interface with Linux ATA Interface */
- memset(&hw, 0, sizeof(hw));
+ /* NOTE: round *down* to meet minimum timings; we count in clocks */
+ ideclk_period = 1000000000UL / rate;
mem = platform_get_resource(pdev, IORESOURCE_MEM, 0);
if (mem == NULL) {
@@ -388,6 +355,7 @@
/* Configure the Palm Chip controller */
palm_bk3710_chipinit(base);
+ memset(&hw, 0, sizeof(hw));
for (i = 0; i < IDE_NR_PORTS - 2; i++)
hw.io_ports_array[i] = (unsigned long)
(base + IDE_PALM_ATA_PRI_REG_OFFSET + i);
@@ -400,6 +368,7 @@
palm_bk3710_port_info.udma_mask = rate < 100000000 ? ATA_UDMA4 :
ATA_UDMA5;
+ /* Register the IDE interface with Linux */
rc = ide_host_add(&palm_bk3710_port_info, hws, NULL);
if (rc)
goto out;