[POWERPC] Refactor DCR code
Previously, DCR support was configured at compile time to either use
MMIO or native dcr instructions. Although this works for most
platforms, it fails on FPGA platforms:
1) Systems may include more than one DCR bus.
2) Systems may be native DCR capable and still use memory mapped DCR interface.
This patch provides runtime support based on the device trees for the
case where CONFIG_PPC_DCR_MMIO and CONFIG_PPC_DCR_NATIVE are both
selected. Previously, this was a poorly defined configuration, which
happened to provide NATIVE support. The runtime selection is made
based on the dcr-controller having a 'dcr-access-method' attribute
in the device tree. If only one of the above options is selected,
then the code uses #defines to select only the used code in order to
avoid introducing overhead in existing usage.
Signed-off-by: Stephen Neuendorffer <stephen.neuendorffer@xilinx.com>
Signed-off-by: Josh Boyer <jwboyer@linux.vnet.ibm.com>
diff --git a/include/asm-powerpc/dcr-native.h b/include/asm-powerpc/dcr-native.h
index f8398ce..72d2b72 100644
--- a/include/asm-powerpc/dcr-native.h
+++ b/include/asm-powerpc/dcr-native.h
@@ -26,14 +26,18 @@
typedef struct {
unsigned int base;
-} dcr_host_t;
+} dcr_host_native_t;
-#define DCR_MAP_OK(host) (1)
+static inline bool dcr_map_ok_native(dcr_host_native_t host)
+{
+ return 1;
+}
-#define dcr_map(dev, dcr_n, dcr_c) ((dcr_host_t){ .base = (dcr_n) })
-#define dcr_unmap(host, dcr_c) do {} while (0)
-#define dcr_read(host, dcr_n) mfdcr(dcr_n + host.base)
-#define dcr_write(host, dcr_n, value) mtdcr(dcr_n + host.base, value)
+#define dcr_map_native(dev, dcr_n, dcr_c) \
+ ((dcr_host_native_t){ .base = (dcr_n) })
+#define dcr_unmap_native(host, dcr_c) do {} while (0)
+#define dcr_read_native(host, dcr_n) mfdcr(dcr_n + host.base)
+#define dcr_write_native(host, dcr_n, value) mtdcr(dcr_n + host.base, value)
/* Device Control Registers */
void __mtdcr(int reg, unsigned int val);