ARM: OMAP2PLUS: DSS: Ensure DSS works correctly if display is enabled in bootloader
Resetting DISPC when a DISPC output is enabled causes the DSS to go into an
inconsistent state. Thus if the bootloader has enabled a display, the hwmod code
cannot reset the DISPC module just like that, but the outputs need to be
disabled first.
Add function dispc_disable_outputs() which disables all active overlay manager
and ensure all frame transfers are completed.
Modify omap_dss_reset() to call this function and clear DSS_CONTROL,
DSS_SDI_CONTROL and DSS_PLL_CONTROL so that DSS is in a clean state when the
DSS2 driver starts.
This resolves the hang issue(caused by a L3 error during boot) seen on the
beagle board C3, which has a factory bootloader that enables display. The issue
is resolved with this patch.
Thanks to Tomi and Sricharan for some additional testing.
Acked-by: Tomi Valkeinen <tomi.valkeinen@ti.com>
Tested-by: R, Sricharan <r.sricharan@ti.com>
Signed-off-by: Archit Taneja <archit@ti.com>
[paul@pwsan.com: restructured code, removed omap_{read,write}l(), removed
cpu_is_omap*() calls and converted to dev_attr]
Signed-off-by: Paul Walmsley <paul@pwsan.com>
diff --git a/arch/arm/mach-omap2/omap_hwmod_common_data.c b/arch/arm/mach-omap2/omap_hwmod_common_data.c
index de832eb..51e5418 100644
--- a/arch/arm/mach-omap2/omap_hwmod_common_data.c
+++ b/arch/arm/mach-omap2/omap_hwmod_common_data.c
@@ -49,3 +49,7 @@
.srst_shift = SYSC_TYPE2_SOFTRESET_SHIFT,
};
+struct omap_dss_dispc_dev_attr omap2_3_dss_dispc_dev_attr = {
+ .manager_count = 2,
+ .has_framedonetv_irq = 0
+};