forcedeth: convert to net_device_ops
Convert this driver to network device ops. Compile tested only.
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/forcedeth.c b/drivers/net/forcedeth.c
index 765210e..dd2e1f6 100644
--- a/drivers/net/forcedeth.c
+++ b/drivers/net/forcedeth.c
@@ -5408,6 +5408,21 @@
return 0;
}
+static const struct net_device_ops nv_netdev_ops = {
+ .ndo_open = nv_open,
+ .ndo_stop = nv_close,
+ .ndo_get_stats = nv_get_stats,
+ .ndo_tx_timeout = nv_tx_timeout,
+ .ndo_change_mtu = nv_change_mtu,
+ .ndo_validate_addr = eth_validate_addr,
+ .ndo_set_mac_address = nv_set_mac_address,
+ .ndo_set_multicast_list = nv_set_multicast,
+ .ndo_vlan_rx_register = nv_vlan_rx_register,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+ .ndo_poll_controller = nv_poll_controller,
+#endif
+};
+
static int __devinit nv_probe(struct pci_dev *pci_dev, const struct pci_device_id *id)
{
struct net_device *dev;
@@ -5527,7 +5542,6 @@
if (id->driver_data & DEV_HAS_VLAN) {
np->vlanctl_bits = NVREG_VLANCONTROL_ENABLE;
dev->features |= NETIF_F_HW_VLAN_RX | NETIF_F_HW_VLAN_TX;
- dev->vlan_rx_register = nv_vlan_rx_register;
}
np->msi_flags = 0;
@@ -5577,25 +5591,16 @@
if (!np->rx_skb || !np->tx_skb)
goto out_freering;
- dev->open = nv_open;
- dev->stop = nv_close;
-
if (!nv_optimized(np))
dev->hard_start_xmit = nv_start_xmit;
else
dev->hard_start_xmit = nv_start_xmit_optimized;
- dev->get_stats = nv_get_stats;
- dev->change_mtu = nv_change_mtu;
- dev->set_mac_address = nv_set_mac_address;
- dev->set_multicast_list = nv_set_multicast;
-#ifdef CONFIG_NET_POLL_CONTROLLER
- dev->poll_controller = nv_poll_controller;
-#endif
+
+ dev->netdev_ops = &nv_netdev_ops;
#ifdef CONFIG_FORCEDETH_NAPI
netif_napi_add(dev, &np->napi, nv_napi_poll, RX_WORK_PER_LOOP);
#endif
SET_ETHTOOL_OPS(dev, &ops);
- dev->tx_timeout = nv_tx_timeout;
dev->watchdog_timeo = NV_WATCHDOG_TIMEO;
pci_set_drvdata(pci_dev, dev);