ARM: dts: mxs: modify mx23/mx28 dts files to use pinctrl headers
Convert mx23/mx28 dts filed to use the pinctrl header files.
NOTE: During automatic conversion of these files to use the pinconfig
definitions an inconsistency has been found in:
arch/arm/boot/dts/imx28-apx4devkit.dts
According to the comment the function for pad SSP2_SS0 should have
been MX28_PAD_SSP2_SS0__GPIO_2_19, while the given value 0x2131
represents: MX28_PAD_SSP2_SS0__AUART3_TX
I used the later (though probably wrong) definition because that's
what is actually being used in the DTB.
Signed-off-by: Lothar Waßmann <LW@KARO-electronics.de>
Signed-off-by: Shawn Guo <shawn.guo@linaro.org>
diff --git a/arch/arm/boot/dts/imx28-cfa10036.dts b/arch/arm/boot/dts/imx28-cfa10036.dts
index 1ec8c94..2474207 100644
--- a/arch/arm/boot/dts/imx28-cfa10036.dts
+++ b/arch/arm/boot/dts/imx28-cfa10036.dts
@@ -10,7 +10,7 @@
*/
/dts-v1/;
-/include/ "imx28.dtsi"
+#include "imx28.dtsi"
/ {
model = "Crystalfontz CFA-10036 Board";
@@ -26,7 +26,7 @@
ssd1306_cfa10036: ssd1306-10036@0 {
reg = <0>;
fsl,pinmux-ids = <
- 0x2073 /* MX28_PAD_SSP0_D7__GPIO_2_7 */
+ MX28_PAD_SSP0_DATA7__GPIO_2_7
>;
fsl,drive-strength = <0>;
fsl,voltage = <1>;
@@ -36,7 +36,7 @@
led_pins_cfa10036: leds-10036@0 {
reg = <0>;
fsl,pinmux-ids = <
- 0x3043 /* MX28_PAD_AUART1_RX__GPIO_3_4 */
+ MX28_PAD_AUART1_RX__GPIO_3_4
>;
fsl,drive-strength = <0>;
fsl,voltage = <1>;
@@ -46,7 +46,7 @@
usb0_otg_cfa10036: otg-10036@0 {
reg = <0>;
fsl,pinmux-ids = <
- 0x0142 /* MX28_PAD_GPMI_READY0__USB0_ID */
+ MX28_PAD_GPMI_RDY0__USB0_ID
>;
fsl,drive-strength = <0>;
fsl,voltage = <1>;