net/fec: improve pm for better suspend/resume
The following commit made a fix to use fec_enet_open/fec_enet_close
over fec_enet_init/fec_stop for suspend/resume, because fec_enet_init
does not allow to have a working network interface at resume.
e3fe8558c7fc182972c3d947d88744482111f304
net/fec: fix pm to survive to suspend/resume
This fix works for i.mx/mxc fec controller, but fails on mx28 fec
which gets a different interrupt logic design. On i.mx fec, interrupt
can be triggered even bit ETHER_EN of ECR register is not set. But
on mx28 fec, ETHER_EN must be set to get interrupt work. Meanwhile,
MII interrupt is mandatory to resume the driver, because MDIO
read/write changed to interrupt mode by commit below.
97b72e4320a9aaa4a7f1592ee7d2da7e2c9bd349
fec: use interrupt for MDIO completion indication
fec_restart/fec_stop comes out as the solution working for both
cases.
Signed-off-by: Shawn Guo <shawn.guo@freescale.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/fec.c b/drivers/net/fec.c
index 47a3c7b..8a1c51f 100644
--- a/drivers/net/fec.c
+++ b/drivers/net/fec.c
@@ -1372,8 +1372,10 @@
if (ndev) {
fep = netdev_priv(ndev);
- if (netif_running(ndev))
- fec_enet_close(ndev);
+ if (netif_running(ndev)) {
+ fec_stop(ndev);
+ netif_device_detach(ndev);
+ }
clk_disable(fep->clk);
}
return 0;
@@ -1388,8 +1390,10 @@
if (ndev) {
fep = netdev_priv(ndev);
clk_enable(fep->clk);
- if (netif_running(ndev))
- fec_enet_open(ndev);
+ if (netif_running(ndev)) {
+ fec_restart(ndev, fep->full_duplex);
+ netif_device_attach(ndev);
+ }
}
return 0;
}