mmc: mmc_spi: Add Card Detect comments and fix CD GPIO case
This patch fixes the MMC SPI driver from doing polling card detect when a
CD GPIO that supports interrupts is specified using the gpios DT property.
Without this patch the DT node below results in the following output:
spi_gpio: spi-gpio { /* SD2 @ CN12 */
compatible = "spi-gpio";
#address-cells = <1>;
#size-cells = <0>;
gpio-sck = <&gpio6 16 GPIO_ACTIVE_HIGH>;
gpio-mosi = <&gpio6 17 GPIO_ACTIVE_HIGH>;
gpio-miso = <&gpio6 18 GPIO_ACTIVE_HIGH>;
num-chipselects = <1>;
cs-gpios = <&gpio6 21 GPIO_ACTIVE_LOW>;
status = "okay";
spi@0 {
compatible = "mmc-spi-slot";
reg = <0>;
voltage-ranges = <3200 3400>;
spi-max-frequency = <25000000>;
gpios = <&gpio6 22 GPIO_ACTIVE_LOW>; /* CD */
};
};
# dmesg | grep mmc
mmc_spi spi32766.0: SD/MMC host mmc0, no WP, no poweroff, cd polling
mmc0: host does not support reading read-only switch, assuming write-enable
mmc0: new SDHC card on SPI
mmcblk0: mmc0:0000 SU04G 3.69 GiB
mmcblk0: p1
With this patch applied the "cd polling" portion above disappears.
Signed-off-by: Magnus Damm <damm+renesas@opensource.se>
Cc: stable@vger.kernel.org # v3.18+
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
1 file changed