I2C: OMAP: Fix the interrupt clearing in OMAP4
On OMAP4 we were writing 1 to IRQENABLE_CLR which cleared only
the arbitration lost interrupt. The patch intends to fix the same by writing 0
to the IE register clearing all interrupts.
This is based on the work done by Vikram Pandita <vikram.pandita@ti.com>.
The changes from the original patch ...
- Does not use the IRQENABLE_CLR register to clear as it is not mentioned
to be legacy register IRQENABLE_CLR helps in atomically
setting/clearing specific interrupts, instead use the OMAP_I2C_IE_REG as we
are clearing all interrupts.
Cc: Vikram Pandita <vikram.pandita@ti.com>
Reviewed-by: Kevin Hilman <khilman@ti.com>
Signed-off-by: Shubhrajyoti D <shubhrajyoti@ti.com>
Signed-off-by: Wolfram Sang <w.sang@pengutronix.de>
diff --git a/drivers/i2c/busses/i2c-omap.c b/drivers/i2c/busses/i2c-omap.c
index c851672..bf07ffd 100644
--- a/drivers/i2c/busses/i2c-omap.c
+++ b/drivers/i2c/busses/i2c-omap.c
@@ -1127,10 +1127,8 @@
u16 iv;
_dev->iestate = omap_i2c_read_reg(_dev, OMAP_I2C_IE_REG);
- if (_dev->dtrev == OMAP_I2C_IP_VERSION_2)
- omap_i2c_write_reg(_dev, OMAP_I2C_IP_V2_IRQENABLE_CLR, 1);
- else
- omap_i2c_write_reg(_dev, OMAP_I2C_IE_REG, 0);
+
+ omap_i2c_write_reg(_dev, OMAP_I2C_IE_REG, 0);
if (_dev->rev < OMAP_I2C_OMAP1_REV_2) {
iv = omap_i2c_read_reg(_dev, OMAP_I2C_IV_REG); /* Read clears */