spi: s3c64xx: add support for exynos7 SPI controller
Exynos7 SPI controller supports only the auto Selection of
CS toggle mode and Exynos7 SoC includes six SPI controllers.
Add support for these changes in Exynos7 SPI controller driver.
Signed-off-by: Padmavathi Venna <padma.v@samsung.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
diff --git a/drivers/spi/Kconfig b/drivers/spi/Kconfig
index 84e7c9e..de2d33d 100644
--- a/drivers/spi/Kconfig
+++ b/drivers/spi/Kconfig
@@ -444,7 +444,7 @@
config SPI_S3C64XX
tristate "Samsung S3C64XX series type SPI"
- depends on PLAT_SAMSUNG
+ depends on (PLAT_SAMSUNG || ARCH_EXYNOS)
select S3C64XX_PL080 if ARCH_S3C64XX
help
SPI driver for Samsung S3C64XX and newer SoCs.
diff --git a/drivers/spi/spi-s3c64xx.c b/drivers/spi/spi-s3c64xx.c
index 480133e..59e07cf 100644
--- a/drivers/spi/spi-s3c64xx.c
+++ b/drivers/spi/spi-s3c64xx.c
@@ -33,8 +33,9 @@
#include <linux/platform_data/spi-s3c64xx.h>
-#define MAX_SPI_PORTS 3
+#define MAX_SPI_PORTS 6
#define S3C64XX_SPI_QUIRK_POLL (1 << 0)
+#define S3C64XX_SPI_QUIRK_CS_AUTO (1 << 1)
/* Registers and bit-fields */
@@ -78,6 +79,7 @@
#define S3C64XX_SPI_SLAVE_AUTO (1<<1)
#define S3C64XX_SPI_SLAVE_SIG_INACT (1<<0)
+#define S3C64XX_SPI_SLAVE_NSC_CNT_2 (2<<4)
#define S3C64XX_SPI_INT_TRAILING_EN (1<<6)
#define S3C64XX_SPI_INT_RX_OVERRUN_EN (1<<5)
@@ -717,7 +719,12 @@
enable_datapath(sdd, spi, xfer, use_dma);
/* Start the signals */
- writel(0, sdd->regs + S3C64XX_SPI_SLAVE_SEL);
+ if (!(sdd->port_conf->quirks & S3C64XX_SPI_QUIRK_CS_AUTO))
+ writel(0, sdd->regs + S3C64XX_SPI_SLAVE_SEL);
+ else
+ writel(readl(sdd->regs + S3C64XX_SPI_SLAVE_SEL)
+ | S3C64XX_SPI_SLAVE_AUTO | S3C64XX_SPI_SLAVE_NSC_CNT_2,
+ sdd->regs + S3C64XX_SPI_SLAVE_SEL);
spin_unlock_irqrestore(&sdd->lock, flags);
@@ -866,13 +873,15 @@
}
pm_runtime_put(&sdd->pdev->dev);
- writel(S3C64XX_SPI_SLAVE_SIG_INACT, sdd->regs + S3C64XX_SPI_SLAVE_SEL);
+ if (!(sdd->port_conf->quirks & S3C64XX_SPI_QUIRK_CS_AUTO))
+ writel(S3C64XX_SPI_SLAVE_SIG_INACT, sdd->regs + S3C64XX_SPI_SLAVE_SEL);
return 0;
setup_exit:
pm_runtime_put(&sdd->pdev->dev);
/* setup() returns with device de-selected */
- writel(S3C64XX_SPI_SLAVE_SIG_INACT, sdd->regs + S3C64XX_SPI_SLAVE_SEL);
+ if (!(sdd->port_conf->quirks & S3C64XX_SPI_QUIRK_CS_AUTO))
+ writel(S3C64XX_SPI_SLAVE_SIG_INACT, sdd->regs + S3C64XX_SPI_SLAVE_SEL);
if (gpio_is_valid(spi->cs_gpio))
gpio_free(spi->cs_gpio);
@@ -946,7 +955,8 @@
sdd->cur_speed = 0;
- writel(S3C64XX_SPI_SLAVE_SIG_INACT, sdd->regs + S3C64XX_SPI_SLAVE_SEL);
+ if (!(sdd->port_conf->quirks & S3C64XX_SPI_QUIRK_CS_AUTO))
+ writel(S3C64XX_SPI_SLAVE_SIG_INACT, sdd->regs + S3C64XX_SPI_SLAVE_SEL);
/* Disable Interrupts - we use Polling if not DMA mode */
writel(0, regs + S3C64XX_SPI_INT_EN);
@@ -1341,6 +1351,15 @@
.quirks = S3C64XX_SPI_QUIRK_POLL,
};
+static struct s3c64xx_spi_port_config exynos7_spi_port_config = {
+ .fifo_lvl_mask = { 0x1ff, 0x7F, 0x7F, 0x7F, 0x7F, 0x1ff},
+ .rx_lvl_offset = 15,
+ .tx_st_done = 25,
+ .high_speed = true,
+ .clk_from_cmu = true,
+ .quirks = S3C64XX_SPI_QUIRK_CS_AUTO,
+};
+
static struct platform_device_id s3c64xx_spi_driver_ids[] = {
{
.name = "s3c2443-spi",
@@ -1374,6 +1393,9 @@
{ .compatible = "samsung,exynos5440-spi",
.data = (void *)&exynos5440_spi_port_config,
},
+ { .compatible = "samsung,exynos7-spi",
+ .data = (void *)&exynos7_spi_port_config,
+ },
{ },
};
MODULE_DEVICE_TABLE(of, s3c64xx_spi_dt_match);