[media] omap3isp: Add CSI configuration registers from control block to ISP resources
Add the registers used to configure the CSI-2 receiver PHY on OMAP3430 and
3630 and map them in the ISP driver. The register is part of the control
block but it only is needed by the ISP driver.
Signed-off-by: Sakari Ailus <sakari.ailus@iki.fi>
Acked-by: Tony Lindgren <tony@atomide.com>
Signed-off-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
diff --git a/arch/arm/mach-omap2/devices.c b/arch/arm/mach-omap2/devices.c
index c72b5a7..c7cb132 100644
--- a/arch/arm/mach-omap2/devices.c
+++ b/arch/arm/mach-omap2/devices.c
@@ -201,6 +201,16 @@
.flags = IORESOURCE_MEM,
},
{
+ .start = OMAP343X_CTRL_BASE + OMAP343X_CONTROL_CSIRXFE,
+ .end = OMAP343X_CTRL_BASE + OMAP343X_CONTROL_CSIRXFE + 3,
+ .flags = IORESOURCE_MEM,
+ },
+ {
+ .start = OMAP343X_CTRL_BASE + OMAP3630_CONTROL_CAMERA_PHY_CTRL,
+ .end = OMAP343X_CTRL_BASE + OMAP3630_CONTROL_CAMERA_PHY_CTRL + 3,
+ .flags = IORESOURCE_MEM,
+ },
+ {
.start = 24 + OMAP_INTC_START,
.flags = IORESOURCE_IRQ,
}