[POWERPC] Add early debug console for CPM serial ports.
This code assumes that the ports have been previously set up, with
buffers in DPRAM.
Signed-off-by: Scott Wood <scottwood@freescale.com>
Acked-by: David Gibson <david@gibson.dropbear.id.au>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
diff --git a/arch/powerpc/Kconfig.debug b/arch/powerpc/Kconfig.debug
index c38bc22..f4e5d22 100644
--- a/arch/powerpc/Kconfig.debug
+++ b/arch/powerpc/Kconfig.debug
@@ -221,6 +221,15 @@
Select this to enable early debugging for IBM 44x chips via the
inbuilt serial port.
+config PPC_EARLY_DEBUG_CPM
+ bool "Early serial debugging for Freescale CPM-based serial ports"
+ depends on SERIAL_CPM
+ select PIN_TLB if PPC_8xx
+ help
+ Select this to enable early debugging for Freescale chips
+ using a CPM-based serial port. This assumes that the bootwrapper
+ has run, and set up the CPM in a particular way.
+
endchoice
config PPC_EARLY_DEBUG_44x_PHYSLOW
@@ -233,4 +242,16 @@
depends PPC_EARLY_DEBUG_44x
default "0x1"
+config PPC_EARLY_DEBUG_CPM_ADDR
+ hex "CPM UART early debug transmit descriptor address"
+ depends on PPC_EARLY_DEBUG_CPM
+ default "0xfa202808" if PPC_EP88XC
+ default "0xf0000808" if CPM2
+ default "0xff002808" if CPM1
+ help
+ This specifies the address of the transmit descriptor
+ used for early debug output. Because it is needed before
+ platform probing is done, all platforms selected must
+ share the same address.
+
endmenu