serial: fsl_lpuart: Remove unused 'bd' variable
Since commit a6d7514b14a6 ("tty: serial: lpuart: add a more accurate baud
rate calculation method") the baud rate is now calculated inside the
lpuart32_serial_setbrg() function, so we no longer need to read the
UARTBAUD register inside lpuart32_set_termios().
The 'bd' variable can be simply removed.
This fixes the following build warning with W=1:
drivers/tty/serial/fsl_lpuart.c: In function 'lpuart32_set_termios':
drivers/tty/serial/fsl_lpuart.c:1652:32: warning: variable 'bd' set but not used [-Wunused-but-set-variable]
Fixes: a6d7514b14a6 ("tty: serial: lpuart: add a more accurate baud rate calculation method")
Signed-off-by: Fabio Estevam <fabio.estevam@nxp.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/tty/serial/fsl_lpuart.c b/drivers/tty/serial/fsl_lpuart.c
index 849c1f9..63f99a0 100644
--- a/drivers/tty/serial/fsl_lpuart.c
+++ b/drivers/tty/serial/fsl_lpuart.c
@@ -1649,12 +1649,11 @@ lpuart32_set_termios(struct uart_port *port, struct ktermios *termios,
{
struct lpuart_port *sport = container_of(port, struct lpuart_port, port);
unsigned long flags;
- unsigned long ctrl, old_ctrl, bd, modem;
+ unsigned long ctrl, old_ctrl, modem;
unsigned int baud;
unsigned int old_csize = old ? old->c_cflag & CSIZE : CS8;
ctrl = old_ctrl = lpuart32_read(&sport->port, UARTCTRL);
- bd = lpuart32_read(&sport->port, UARTBAUD);
modem = lpuart32_read(&sport->port, UARTMODIR);
/*
* only support CS8 and CS7, and for CS7 must enable PE.