tree 6ab76387d836075f75fcb7ece70c0b76f241b509
parent 83337dae6ca94d801b6700600244865cd694205b
author Gerrit Renker <gerrit@erg.abdn.ac.uk> 1220506219 +0200
committer Gerrit Renker <gerrit@erg.abdn.ac.uk> 1220507138 +0200

dccp ccid-2: Remove redundant sanity tests

This removes the ccid2_hc_tx_check_sanity function: it is redundant.

Details:
========
The tx_check_sanity function performs three tests:
 1) it checks that the circular TX list is sorted
    - in ascending order of sequence number (ccid2s_seq) 
    - and time (ccid2s_sent),
    - in the direction from `tail' (hctx_seqt) to `head' (hctx_seqh);
 2) it ensures that the entire list has the length seqbufc * CCID2_SEQBUF_LEN;
 3) it ensures that pipe equals the number of packets that were not
    marked `acked' (ccid2s_acked) between `tail' and `head'.

The following argues that each of these tests is redundant, this can be verified
by going through the code.

(1) is not necessary, since both time and GSS increase from one packet to the
next, so that subsequent insertions in tx_packet_sent (which advance the `head'
pointer) will be in ascending order of time and sequence number.

In (2), the length of the list is always equal to seqbufc times CCID2_SEQBUF_LEN
(set to 1024) unless allocation caused an earlier failure, because:
 * at initialisation (tx_init), there is one chunk of size 1024 and seqbufc=1;
 * subsequent calls to tx_alloc_seq take place whenever head->next == tail in 
   tx_packet_sent; then a new chunk of size 1024 is inserted between head and
   tail, and seqbufc is incremented by one.

To show that (3) is redundant requires looking at two cases. 

The `pipe' variable of the TX socket is incremented only in tx_packet_sent, and 
decremented in tx_packet_recv.  When head == tail (TX history empty) then pipe
should be 0, which is the case directly after initialisation and after a
retransmission timeout has occurred (ccid2_hc_tx_rto_expire).

The first case involves parsing Ack Vectors for packets recorded in the live
portion of the buffer, between tail and head. For each packet marked by the
receiver as received (state 0) or ECN-marked (state 1), pipe is decremented by
one, so for all such packets the BUG_ON in tx_check_sanity will not trigger.

The second case is the loss detection in the second half of tx_packet_recv,
below the comment "Check for NUMDUPACK".

The first while-loop here ensures that the sequence number of `seqp' is either
above or equal to `high_ack', or otherwise equal to the highest sequence number
sent so far (of the entry head->prev, as head points to the next unsent entry).
The next while-loop ("while (1)") counts the number of acked packets starting
from that position of seqp, going backwards in the direction from head->prev to
tail. If NUMDUPACK=3 such packets were counted within this loop, `seqp' points
to the last acknowledged packet of these, and the "if (done == NUMDUPACK)" block
is entered next. 
The while-loop contained within that block in turn traverses the list backwards,
from head to tail; the position of `seqp' is saved in the variable `last_acked'. 
For each packet not marked as `acked', a congestion event is triggered within 
the loop, and pipe is decremented. The loop terminates when `seqp' has reached
`tail', whereupon tail is set to the position previously stored in `last_acked'.
Thus, between `last_acked' and the previous position of `tail', 
 - pipe has been decremented earlier if the packet was marked as state 0 or 1;
 - pipe was decremented if the packet was not marked as acked.
That is, pipe has been decremented by the number of packets between `last_acked'
and the previous position of `tail'. As a consequence, pipe now again reflects
the number of packets which have not (yet) been acked between the new position
of tail (at `last_acked') and head->prev, or 0 if head==tail. The result is that
the BUG_ON condition in check_sanity will also not be triggered, hence the test
(3) is also redundant.

Signed-off-by: Gerrit Renker <gerrit@erg.abdn.ac.uk>