USB: EHCI: remove ehci_port_power() routine
This patch (as1623) removes the ehci_port_power() routine and all the
places that call it. There's no reason for ehci-hcd to change the
port power settings; the hub driver takes care of all that stuff.
There is one exception: When the controller is resumed from
hibernation or following a loss of power, the ports that are supposed
to be handed over to a companion controller must be powered on first.
Otherwise the handover won't work. This process is not visible to the
hub driver, so it has to be handled in ehci-hcd.
Signed-off-by: Alan Stern <stern@rowland.harvard.edu>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/usb/host/ehci-grlib.c b/drivers/usb/host/ehci-grlib.c
index 3180cb3..da42695 100644
--- a/drivers/usb/host/ehci-grlib.c
+++ b/drivers/usb/host/ehci-grlib.c
@@ -34,22 +34,6 @@
#define GRUSBHC_HCIVERSION 0x0100 /* Known value of cap. reg. HCIVERSION */
-/* called during probe() after chip reset completes */
-static int ehci_grlib_setup(struct usb_hcd *hcd)
-{
- struct ehci_hcd *ehci = hcd_to_ehci(hcd);
- int retval;
-
- retval = ehci_setup(hcd);
- if (retval)
- return retval;
-
- ehci_port_power(ehci, 1);
-
- return retval;
-}
-
-
static const struct hc_driver ehci_grlib_hc_driver = {
.description = hcd_name,
.product_desc = "GRLIB GRUSBHC EHCI",
@@ -64,7 +48,7 @@
/*
* basic lifecycle operations
*/
- .reset = ehci_grlib_setup,
+ .reset = ehci_setup,
.start = ehci_run,
.stop = ehci_stop,
.shutdown = ehci_shutdown,