bnx2x: Limit 1G link enforcement
Change 1G-SFP module detection by verifying not only that it's not
compliant with 10G-Ethernet, but also that it's 1G-ethernet compliant.
Signed-off-by: Yaniv Rosner <Yaniv.Rosner@qlogic.com>
Signed-off-by: Yuval Mintz <Yuval.Mintz@qlogic.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_link.c b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_link.c
index 549549e..778e4cd 100644
--- a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_link.c
+++ b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_link.c
@@ -8119,10 +8119,11 @@
case SFP_EEPROM_CON_TYPE_VAL_LC:
case SFP_EEPROM_CON_TYPE_VAL_RJ45:
check_limiting_mode = 1;
- if ((val[SFP_EEPROM_10G_COMP_CODE_ADDR] &
+ if (((val[SFP_EEPROM_10G_COMP_CODE_ADDR] &
(SFP_EEPROM_10G_COMP_CODE_SR_MASK |
SFP_EEPROM_10G_COMP_CODE_LR_MASK |
- SFP_EEPROM_10G_COMP_CODE_LRM_MASK)) == 0) {
+ SFP_EEPROM_10G_COMP_CODE_LRM_MASK)) == 0) &&
+ (val[SFP_EEPROM_1G_COMP_CODE_ADDR] != 0)) {
DP(NETIF_MSG_LINK, "1G SFP module detected\n");
phy->media_type = ETH_PHY_SFP_1G_FIBER;
if (phy->req_line_speed != SPEED_1000) {