arcnet: Use normal kernel spacing style
Standardized spacing is easier to read.
git diff -w shows no differences.
objdiff shows no differences.
Signed-off-by: Joe Perches <joe@perches.com>
Signed-off-by: Michael Grzeschik <m.grzeschik@pengutronix.de>
diff --git a/drivers/net/arcnet/arc-rawmode.c b/drivers/net/arcnet/arc-rawmode.c
index 705e6ce..49f5819 100644
--- a/drivers/net/arcnet/arc-rawmode.c
+++ b/drivers/net/arcnet/arc-rawmode.c
@@ -1,6 +1,6 @@
/*
* Linux ARCnet driver - "raw mode" packet encapsulation (no soft headers)
- *
+ *
* Written 1994-1999 by Avery Pennarun.
* Derived from skeleton.c by Donald Becker.
*
@@ -109,7 +109,7 @@
skb_put(skb, length + ARC_HDR_SIZE);
skb->dev = dev;
- pkt = (struct archdr *) skb->data;
+ pkt = (struct archdr *)skb->data;
skb_reset_mac_header(skb);
skb_pull(skb, ARC_HDR_SIZE);
@@ -136,7 +136,7 @@
unsigned short type, uint8_t daddr)
{
int hdr_size = ARC_HDR_SIZE;
- struct archdr *pkt = (struct archdr *) skb_push(skb, hdr_size);
+ struct archdr *pkt = (struct archdr *)skb_push(skb, hdr_size);
/*
* Set the source hardware address.
@@ -150,7 +150,7 @@
/* see linux/net/ethernet/eth.c to see where I got the following */
if (dev->flags & (IFF_LOOPBACK | IFF_NOARP)) {
- /*
+ /*
* FIXME: fill in the last byte of the dest ipaddr here to better
* comply with RFC1051 in "noarp" mode.
*/
@@ -192,7 +192,7 @@
hard->offset[0] = ofs = 256 - length;
BUGMSG(D_DURING, "prepare_tx: length=%d ofs=%d\n",
- length,ofs);
+ length, ofs);
lp->hw.copy_to_card(dev, bufnum, 0, hard, ARC_HDR_SIZE);
lp->hw.copy_to_card(dev, bufnum, ofs, &pkt->soft, length);