net: bcmgenet: correctly suspend and resume PHY device

Make sure that we properly suspend and resume the PHY device when we
enter low power modes. We had two calls to bcmgenet_mii_reset() which
will issue a software-reset to the PHY without using the PHY library,
get rid of them since they are completely bogus and mess up with the PHY
library state. Make sure that we reset the PHY library cached values
(link, pause and duplex) to allow the link adjustment callback to be
invoked when needed.

Fixes: b6e978e50444 ("net: bcmgenet: add suspend/resume callbacks")
Fixes: 1c1008c793fa4 ("net: bcmgenet: add main driver file")
Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/broadcom/genet/bcmgenet.c b/drivers/net/ethernet/broadcom/genet/bcmgenet.c
index 7a3661c..90eb9c4 100644
--- a/drivers/net/ethernet/broadcom/genet/bcmgenet.c
+++ b/drivers/net/ethernet/broadcom/genet/bcmgenet.c
@@ -739,7 +739,6 @@
 
 	case GENET_POWER_PASSIVE:
 		/* Power down LED */
-		bcmgenet_mii_reset(priv->dev);
 		if (priv->hw_params->flags & GENET_HAS_EXT) {
 			reg = bcmgenet_ext_readl(priv, EXT_EXT_PWR_MGMT);
 			reg |= (EXT_PWR_DOWN_PHY |
@@ -779,7 +778,9 @@
 	}
 
 	bcmgenet_ext_writel(priv, reg, EXT_EXT_PWR_MGMT);
-	bcmgenet_mii_reset(priv->dev);
+
+	if (mode == GENET_POWER_PASSIVE)
+		bcmgenet_mii_reset(priv->dev);
 }
 
 /* ioctl handle special commands that are not present in ethtool. */
@@ -2164,6 +2165,10 @@
 	 * disabled no new work will be scheduled.
 	 */
 	cancel_work_sync(&priv->bcmgenet_irq_work);
+
+	priv->old_pause = -1;
+	priv->old_link = -1;
+	priv->old_duplex = -1;
 }
 
 static int bcmgenet_close(struct net_device *dev)
@@ -2611,6 +2616,8 @@
 
 	bcmgenet_netif_stop(dev);
 
+	phy_suspend(priv->phydev);
+
 	netif_device_detach(dev);
 
 	/* Disable MAC receive */
@@ -2693,6 +2700,8 @@
 
 	netif_device_attach(dev);
 
+	phy_resume(priv->phydev);
+
 	bcmgenet_netif_start(dev);
 
 	return 0;