powerpc/64: Enable use of radix MMU under hypervisor on POWER9
To use radix as a guest, we first need to tell the hypervisor via
the ibm,client-architecture call first that we support POWER9 and
architecture v3.00, and that we can do either radix or hash and
that we would like to choose later using an hcall (the
H_REGISTER_PROC_TBL hcall).
Then we need to check whether the hypervisor agreed to us using
radix. We need to do this very early on in the kernel boot process
before any of the MMU initialization is done. If the hypervisor
doesn't agree, we can't use radix and therefore clear the radix
MMU feature bit.
Later, when we have set up our process table, which points to the
radix tree for each process, we need to install that using the
H_REGISTER_PROC_TBL hcall.
Signed-off-by: Paul Mackerras <paulus@ozlabs.org>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>
diff --git a/arch/powerpc/include/asm/hvcall.h b/arch/powerpc/include/asm/hvcall.h
index 77ff1ba..54d11b3 100644
--- a/arch/powerpc/include/asm/hvcall.h
+++ b/arch/powerpc/include/asm/hvcall.h
@@ -276,6 +276,7 @@
#define H_GET_MPP_X 0x314
#define H_SET_MODE 0x31C
#define H_CLEAR_HPT 0x358
+#define H_REGISTER_PROC_TBL 0x37C
#define H_SIGNAL_SYS_RESET 0x380
#define MAX_HCALL_OPCODE H_SIGNAL_SYS_RESET
@@ -313,6 +314,16 @@
#define H_SIGNAL_SYS_RESET_ALL_OTHERS -2
/* >= 0 values are CPU number */
+/* Flag values used in H_REGISTER_PROC_TBL hcall */
+#define PROC_TABLE_OP_MASK 0x18
+#define PROC_TABLE_DEREG 0x10
+#define PROC_TABLE_NEW 0x18
+#define PROC_TABLE_TYPE_MASK 0x06
+#define PROC_TABLE_HPT_SLB 0x00
+#define PROC_TABLE_HPT_PT 0x02
+#define PROC_TABLE_RADIX 0x04
+#define PROC_TABLE_GTSE 0x01
+
#ifndef __ASSEMBLY__
/**