mmc: sdhci-s3c: Check if clk_set_rate() succeeds
It is possible that we may fail to set the clock rate, if we do so then
log the failure and don't bother reprogramming the IP.
Signed-off-by: Mark Brown <broonie@linaro.org>
Acked-by: Jaehoon Chung <jh80.chung@samsung.com>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
diff --git a/drivers/mmc/host/sdhci-s3c.c b/drivers/mmc/host/sdhci-s3c.c
index 0ce6eb17..4f7a6321 100644
--- a/drivers/mmc/host/sdhci-s3c.c
+++ b/drivers/mmc/host/sdhci-s3c.c
@@ -300,6 +300,7 @@
struct device *dev = &ourhost->pdev->dev;
unsigned long timeout;
u16 clk = 0;
+ int ret;
host->mmc->actual_clock = 0;
@@ -311,7 +312,12 @@
sdhci_s3c_set_clock(host, clock);
- clk_set_rate(ourhost->clk_bus[ourhost->cur_clk], clock);
+ ret = clk_set_rate(ourhost->clk_bus[ourhost->cur_clk], clock);
+ if (ret != 0) {
+ dev_err(dev, "%s: failed to set clock rate %uHz\n",
+ mmc_hostname(host->mmc), clock);
+ return;
+ }
clk = SDHCI_CLOCK_INT_EN;
sdhci_writew(host, clk, SDHCI_CLOCK_CONTROL);