wireless: add VHT (802.11ac) definitions
Add the VHT definitions to be used by drivers supporting it.
Signed-off-by: Mahesh Palivela <maheshp@posedge.com>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
diff --git a/include/linux/ieee80211.h b/include/linux/ieee80211.h
index 318fc1f..abf0e5fe 100644
--- a/include/linux/ieee80211.h
+++ b/include/linux/ieee80211.h
@@ -1092,6 +1092,73 @@
#define WLAN_HT_SMPS_CONTROL_STATIC 1
#define WLAN_HT_SMPS_CONTROL_DYNAMIC 3
+#define VHT_MCS_SUPPORTED_SET_SIZE 8
+
+struct ieee80211_vht_capabilities {
+ __le32 vht_capabilities_info;
+ u8 vht_supported_mcs_set[VHT_MCS_SUPPORTED_SET_SIZE];
+} __packed;
+
+struct ieee80211_vht_operation {
+ u8 vht_op_info_chwidth;
+ u8 vht_op_info_chan_center_freq_seg1_idx;
+ u8 vht_op_info_chan_center_freq_seg2_idx;
+ __le16 vht_basic_mcs_set;
+} __packed;
+
+/**
+ * struct ieee80211_vht_mcs_info - VHT MCS information
+ * @rx_mcs_map: RX MCS map 2 bits for each stream, total 8 streams
+ * @rx_highest: Indicates highest long GI VHT PPDU data rate
+ * STA can receive. Rate expressed in units of 1 Mbps.
+ * If this field is 0 this value should not be used to
+ * consider the highest RX data rate supported.
+ * @tx_mcs_map: TX MCS map 2 bits for each stream, total 8 streams
+ * @tx_highest: Indicates highest long GI VHT PPDU data rate
+ * STA can transmit. Rate expressed in units of 1 Mbps.
+ * If this field is 0 this value should not be used to
+ * consider the highest TX data rate supported.
+ */
+struct ieee80211_vht_mcs_info {
+ __le16 rx_mcs_map;
+ __le16 rx_highest;
+ __le16 tx_mcs_map;
+ __le16 tx_highest;
+} __packed;
+
+#define IEEE80211_VHT_MCS_ZERO_TO_SEVEN_SUPPORT 0
+#define IEEE80211_VHT_MCS_ZERO_TO_EIGHT_SUPPORT 1
+#define IEEE80211_VHT_MCS_ZERO_TO_NINE_SUPPORT 2
+#define IEEE80211_VHT_MCS_NOT_SUPPORTED 3
+
+/* 802.11ac VHT Capabilities */
+#define IEEE80211_VHT_CAP_MAX_MPDU_LENGTH_3895 0x00000000
+#define IEEE80211_VHT_CAP_MAX_MPDU_LENGTH_7991 0x00000001
+#define IEEE80211_VHT_CAP_MAX_MPDU_LENGTH_11454 0x00000002
+#define IEEE80211_VHT_CAP_SUPP_CHAN_WIDTH_160MHZ 0x00000004
+#define IEEE80211_VHT_CAP_SUPP_CHAN_WIDTH_160_80PLUS80MHZ 0x00000008
+#define IEEE80211_VHT_CAP_RXLDPC 0x00000010
+#define IEEE80211_VHT_CAP_SHORT_GI_80 0x00000020
+#define IEEE80211_VHT_CAP_SHORT_GI_160 0x00000040
+#define IEEE80211_VHT_CAP_TXSTBC 0x00000080
+#define IEEE80211_VHT_CAP_RXSTBC_1 0x00000100
+#define IEEE80211_VHT_CAP_RXSTBC_2 0x00000200
+#define IEEE80211_VHT_CAP_RXSTBC_3 0x00000300
+#define IEEE80211_VHT_CAP_RXSTBC_4 0x00000400
+#define IEEE80211_VHT_CAP_SU_BEAMFORMER_CAPABLE 0x00000800
+#define IEEE80211_VHT_CAP_SU_BEAMFORMEE_CAPABLE 0x00001000
+#define IEEE80211_VHT_CAP_BEAMFORMER_ANTENNAS_MAX 0x00006000
+#define IEEE80211_VHT_CAP_SOUNDING_DIMENTION_MAX 0x00030000
+#define IEEE80211_VHT_CAP_MU_BEAMFORMER_CAPABLE 0x00080000
+#define IEEE80211_VHT_CAP_MU_BEAMFORMEE_CAPABLE 0x00100000
+#define IEEE80211_VHT_CAP_VHT_TXOP_PS 0x00200000
+#define IEEE80211_VHT_CAP_HTC_VHT 0x00400000
+#define IEEE80211_VHT_CAP_MAX_A_MPDU_LENGTH_EXPONENT 0x00800000
+#define IEEE80211_VHT_CAP_VHT_LINK_ADAPTATION_VHT_UNSOL_MFB 0x08000000
+#define IEEE80211_VHT_CAP_VHT_LINK_ADAPTATION_VHT_MRQ_MFB 0x0c000000
+#define IEEE80211_VHT_CAP_RX_ANTENNA_PATTERN 0x10000000
+#define IEEE80211_VHT_CAP_TX_ANTENNA_PATTERN 0x20000000
+
/* Authentication algorithms */
#define WLAN_AUTH_OPEN 0
#define WLAN_AUTH_SHARED_KEY 1
@@ -1352,6 +1419,9 @@
WLAN_EID_DSE_REGISTERED_LOCATION = 58,
WLAN_EID_SUPPORTED_REGULATORY_CLASSES = 59,
WLAN_EID_EXT_CHANSWITCH_ANN = 60,
+
+ WLAN_EID_VHT_CAPABILITY = 191,
+ WLAN_EID_VHT_OPERATION = 192,
};
/* Action category code */